Rock Auto - Prime Ad

Search:

Tag: pressure

Page 1 of 30 1 2 3 4

Search: Search took 0.32 seconds.

  1. Restoration Station - First-Hand Experience Wanted

    Started by Mudman, 08-28-2015 08:39 PM
    air, bumper, effect, factory, front, ground fx, hall, intake, lancer, mount, parts, pcv, pickup, pressure, restoration, rotor, shelby, stalling, steering, swap, threads, valve, wanted
    • Replies: 7
    • Views: 162
    Last Post: Today 12:28 PM
    by mopar-tech  Go to last post
  2. TIII Misfire at Startup, Otherwise Running Fine

    Started by jckrieger, 08-26-2015 10:45 PM
    cam, crank, engine, harness, injectors, misfire, pressure, r/t, radiator, startup, wires
    • Replies: 3
    • Views: 103
    Last Post: 08-28-2015 06:36 PM
    by jckrieger  Go to last post
  3. Car slow to build boost, won't go past 10 pounds

    Started by 3Bar_Mopar, 08-04-2015 05:37 PM
    4 Pages
    1 2 3 ... 4
    • Replies: 75
    • Views: 1,355
    Last Post: Today 10:36 AM
    by 3Bar_Mopar  Go to last post
    • Replies: 1
    • Views: 248
    Last Post: 08-09-2015 07:53 PM
    by spiro440  Go to last post
  4. TIII Pushing Oil Bad

    Started by DoubleD, 08-03-2015 01:40 PM
    baffled, blue, boost, engine, exhaust, factory, fitting, head, oil, pcv, pressure, problem, rack, stumped, valve
    • Replies: 1
    • Views: 250
    Last Post: 08-08-2015 12:43 PM
    by iTurbo  Go to last post
  5. Transmission Used TU Ceramic 4 puck clutch Yellow PP 18 spline

    Started by jefo, 08-02-2015 11:46 PM
    a523, brake, clutch, for sale, paint, plate, pressure, sale, transmission, tu, van, wear
    • Replies: 4
    • Views: 288
    Last Post: 08-03-2015 08:42 PM
    by Pat  Go to last post
  6. oil switch/sender issue

    Started by thedon809, 07-30-2015 09:28 PM
    body, cluster, gauge, idle, l body, oil, original, pressure, problem, smec, video, wire
    • Replies: 6
    • Views: 212
    Last Post: 08-02-2015 07:52 PM
    by thedon809  Go to last post
  7. Dual intercooler.... serial vs parallel???

    Started by chromguy, 07-18-2015 04:27 PM
    • Replies: 14
    • Views: 359
    Last Post: 07-20-2015 01:07 PM
    by mopar-tech  Go to last post
  8. Wastegate actuator pressure vs extension data

    Started by acannell, 07-16-2015 10:06 PM
    media, pressure, wastegate
    • Replies: 1
    • Views: 93
    Last Post: 07-16-2015 10:32 PM
    by acannell  Go to last post
  9. Turbine exit hole dia at various stages?

    Started by acannell, 07-12-2015 10:09 PM
    2 Pages
    1 2
    • Replies: 33
    • Views: 682
    Last Post: 07-17-2015 05:49 PM
    by acannell  Go to last post
  10. Daytona Turbo Z many tiny issues need advise

    Started by Lee'sdaytona, 07-13-2015 09:06 PM
    air, aries, bushings, caravan, daytona, door, factory, fender, media, oil, pressure, radio, t-top, turbo, turbo z, wire
    • Replies: 0
    • Views: 106
    Last Post: 07-13-2015 09:06 PM
    by Lee'sdaytona  Go to last post
  11. car bogging down when flooring throttle

    Started by TJ Schulze, 07-11-2015 04:42 PM
    1990, 2.4, boost, daytona, dodge, electronics, factory, floor, fuel, idle, map, map sensor, pressure, problem, red, rough, srt, srt4, stumped
    • Replies: 9
    • Views: 274
    Last Post: 08-22-2015 01:35 AM
    by TJ Schulze  Go to last post
  12. TIII Boost Control

    Started by DoubleD, 07-06-2015 01:43 PM
    boost, control, pressure, sbec, sbecii, tiii, tu, tune
    • Replies: 11
    • Views: 278
    Last Post: 08-25-2015 06:47 PM
    by ShelGame  Go to last post

    Forum:
    EFI Tuning

    • Replies: 9
    • Views: 496
    Last Post: 07-20-2015 12:30 AM
    by mr b  Go to last post
    • Replies: 2
    • Views: 184
    Last Post: 07-04-2015 10:47 AM
    by tryingbe  Go to last post
    • Replies: 6
    • Views: 215
    Last Post: 06-27-2015 01:53 AM
    by 88C/S  Go to last post

    Forum:
    EFI Tuning

  13. General Go Fast 12valve 3.0 parts

    Started by Sundance 6g72, 06-25-2015 10:52 AM
    3.0, 6g72, a543, cams, clean, dyno, exhaust, fuel, gear, injectors, locks, log manifold, manifold, parts, power, pressure, pump, shifter, specs, sundance, thread, trans, turbo, valve
    • Replies: 6
    • Views: 285
    Last Post: 06-28-2015 10:48 PM
    by Sundance 6g72  Go to last post
    • Replies: 0
    • Views: 133
    Last Post: 06-21-2015 03:45 PM
    by tryingbe  Go to last post
    • Replies: 22
    • Views: 481
    Last Post: 06-25-2015 05:36 PM
    by crusty shadow  Go to last post
  14. Good machine shop in SE Michigan?

    Started by ShelGame, 06-19-2015 02:10 PM
    block, head, omni, pistons, pressure, swap
    • Replies: 0
    • Views: 107
    Last Post: 06-19-2015 02:10 PM
    by ShelGame  Go to last post
    • Replies: 8
    • Views: 418
    Last Post: 06-11-2015 04:17 PM
    by moparzrule  Go to last post
  15. Breaking in the R/T

    Started by DoubleD, 06-03-2015 10:29 AM
    2 Pages
    1 2
    front, gauge, gear, oil, pressure, r/t, radiator, repair, tank, valve
    • Replies: 22
    • Views: 444
    Last Post: 06-05-2015 11:12 AM
    by DoubleD  Go to last post
  16. 97 Neon brakes won't lock up

    Started by cordes, 05-28-2015 09:26 PM
    2 Pages
    1 2
    air, brakes, drag, front, mph, neon, piston, pressure, problem, pump, r/t, rear, vacuum, valve, wanted
    • Replies: 33
    • Views: 938
    Last Post: 06-01-2015 10:27 PM
    by cordes  Go to last post
  17. few questions on rebuilding 2.5l

    Started by Fox, 05-29-2015 12:09 AM
    2.5, clean, effect, head, pressure, problem, turbo
    • Replies: 19
    • Views: 660
    Last Post: 06-13-2015 11:59 PM
    by Fox  Go to last post
    • Replies: 3
    • Views: 296
    Last Post: 05-29-2015 11:07 PM
    by Aries_Turbo  Go to last post
Results 1 to 25 of 731
Page 1 of 30 1 2 3 4