Search Results - Turbo Mopar Forums

Cooling Mod #4 question

Started by kwimmer, 02-09-2015 06:22 PM

block, cooling, head, heater, pump, water, water pump

Replies: 6
Views: 3,029

Last Post By:: Last Post: 02-10-2015 01:19 PM; by Shadow

Forum:
Maintenance & General Tech

Engine 2.2 Bare Common Block needed(w/mains)

Started by knownenemy, 02-04-2015 10:39 PM

block, build, caps, common block, factory, parts

Replies: 7
Views: 2,252

Last Post By:: Last Post: 02-10-2015 03:59 PM; by knownenemy

Forum:
Parts Wanted

2.2 LW rods - good for 220hp?

Started by ShelGame, 02-04-2015 09:32 PM

2 Pages •: 1 2

'84, '87, 2.5, air, block, caps, carb, cast, common block, crank, engine, glh, injectors, intake, intercooler, kit, map, non-common block, pistons, project, pump, racing, rods, sdac, turbo

Replies: 39
Views: 11,057

Last Post By:: Last Post: 04-04-2016 12:31 AM; by iTurbo

Forum:
Engine - Block, Piston, Heads, Intakes

Engine 1992 Turbo III Engine Whole or Parts +.040 JEs Ti Retainers

Started by Master Tech, 02-04-2015 12:21 AM

block, crank, engine, forged, fuel, head, manifolds, parts, pistons, r/t, rail, rebuild, rings, rods, skirts, t2, t3, turbo

Replies: 12
Views: 5,332

Last Post By:: Last Post: 10-24-2015 09:49 PM; by LeYepez

Forum:
Parts For Sale

My '92 Sundance refresh, rebuild, & conversion log

Started by cjbintx, 02-01-2015 03:40 PM

3 Pages •: 1 2 3

block, body, clutch, conversion, crank, egr, exhaust, head, p-body, parts, pump, radiator, rebuild, shift, smell, sundance, suspension, trade, tranny, transmission, turbo, valve, water, water pump, wear

Replies: 59
Views: 17,938

Last Post By:: Last Post: 12-21-2015 11:24 AM; by Vigo

Forum:
Project Log

Engine Looking for a 2.5 turbo motor

Started by BIG PSI, 01-30-2015 03:44 PM

2.5, block, intake, ohio, short block, turbo

Replies: 5
Views: 2,106

Last Post By:: Last Post: 02-19-2015 12:24 AM; by BIG PSI

Forum:
Parts Wanted

TIII Center oil drain-back mod

Started by Lotashelbys, 01-25-2015 11:41 AM

block, csx, draw, drill, factory, fitting, front, gasket, head, head gasket, idle, install, intake, media, oil, pcv, sdac, summer, tiii, valve, wanted

Replies: 6
Views: 2,707

Last Post By:: Last Post: 01-27-2015 02:18 PM; by 5DIGITS

Forum:
16v Factory Engines

ARP Head stud part number

Started by DevoBuzz, 01-23-2015 09:20 PM

arp head, block, common block, engine, head

Replies: 6
Views: 1,933

Last Post By:: Last Post: 01-27-2015 02:37 AM; by supercrackerbox

Forum:
"I need help!"

Nitrous Experts - Please Advise

Started by 1984rampage, 01-20-2015 11:16 AM

5 speed, automatic, block, body, digital, dodge, fuel, fuel pump, gauge, gear, glh, ignition, intercooler, manual, nitrous, omni, pump, shadow, shift, steering wheel, trans, tu, tuning, turbo

Replies: 13
Views: 5,279

Last Post By:: Last Post: 01-24-2015 07:34 AM; by ATaylorRacing

Forum:
H2O / N2O/ Alky Injection

GLHS hybrid project, 10+yr build and counting

Started by GLHS320, 01-20-2015 10:11 PM

8 Pages •: 1 2 3 ... 8

16v, 2.2l, 2.4l, auto, block, build, crank, engine, exhaust, forged, glhs, head, hybrid, intake, mopar, parts, project, sdac, specs, spirit, starter, steve, wires

Replies: 148
Views: 46,578

Last Post By:: Last Post: 10-20-2017 10:58 PM; by 2.216VTurbo

Forum:
Project Log

For Sale 1989 Plymouth Sundance Shell for parts, no title

Started by moparman76_69, 01-19-2015 04:50 PM

1989, block, broken, dash, front, head, interior, neon, parts, plymouth, rear, roller, shell, short block, srt, struts, sundance, transmission, wanted, wheels

Replies: 1
Views: 1,588

Last Post By:: Last Post: 01-26-2015 11:45 AM; by fcasta308

Forum:
Cars

Need help! Picture or explanation...pass side motor mount bracket, etc

Started by strang3majik, 01-04-2015 03:08 PM

block, bracket, engine, front, gears, motor mount, mount, need help, omni, timing, trans

Replies: 6
Views: 2,010

Last Post By:: Last Post: 01-05-2015 08:38 PM; by Johnny

Forum:
"I need help!"

Engine WTB 2.2 short or long block!

Started by Sccacivic12, 01-04-2015 12:53 AM

Replies: 5
Views: 2,010

Last Post By:: Last Post: 01-11-2015 08:22 PM; by Sccacivic12

Forum:
Parts Wanted

Big Block V8 Dodge Omni Build

Started by 88omnipotent, 12-31-2014 01:16 AM

4 Pages •: 1 2 3 ... 4

axle, big, block, build, dodge, dodge omni, engine, exhaust, factory, front, glh, glhs, glht, intake, kit, manifolds, media, mopar, naturally aspirated, omni, project, suspension, turbo

Replies: 75
Views: 42,919

Last Post By:: Last Post: 01-26-2018 12:30 PM; by 10ChallSRT8

Forum:
Project Log

Engine WANTED: Head, Turbo, Injectors, 3 bar MAP

Started by LeBaronMike, 12-30-2014 11:19 AM

block, build, crank, engine, garrett, head, holset, injectors, map, map sensor, parts, pistons, rods, short block, turbo, wanted

Replies: 1
Views: 1,372

Last Post By:: Last Post: 01-03-2015 10:53 AM; by ajakeski

Forum:
Parts Wanted

Engine delete this thread please

Started by LeBaronMike, 12-30-2014 11:15 AM

block, build, crank, engine, garrett, head, holset, injectors, map, map sensor, parts, pistons, rods, short block, turbo

Replies: 0
Views: 1,152

Last Post By:: Last Post: 12-30-2014 11:15 AM; by LeBaronMike

Forum:
Parts For Sale

piston expansion measurements

Started by acannell, 12-29-2014 03:45 PM

2.5, block, cast, forged, media, piston, water

Replies: 11
Views: 3,825

Last Post By:: Last Post: 01-17-2015 11:06 PM; by acannell

Forum:
Engine - Block, Piston, Heads, Intakes

new Venolia forged pistons only $80 each + s/h??

Started by acannell, 12-23-2014 06:27 PM

2.5, block, california, cast, cheap, forged, list, locks, mahles, media, pistons, rings

Replies: 15
Views: 5,538

Last Post By:: Last Post: 12-28-2014 04:22 PM; by turbovanman²

Forum:
Maintenance & General Tech

Making my car more comfortable for long drives

Started by DoubleD, 12-23-2014 11:41 AM

2 Pages •: 1 2

92 daytona, block, body, broken, bushings, compression, control, daytona, engine, exhaust, floor, front, iroc, iroc r/t, motor mount, mount, oil, problem, r/t, rear, short block, smell, struts, summer, turbo

Replies: 25
Views: 8,180

Last Post By:: Last Post: 03-10-2015 10:32 AM; by Force Fed Mopar

Forum:
Maintenance & General Tech

forged piston question

Started by acannell, 12-22-2014 09:42 PM

2 Pages •: 1 2

block, common block, compression, crank, factory, forged, locks, piston, pistons, power, problem, project, rings, rods

Replies: 25
Views: 16,051

Last Post By:: Last Post: 12-25-2014 12:35 AM; by Force Fed Mopar

Forum:
Engine - Block, Piston, Heads, Intakes

Engine NEW under drive crank pulley

Started by markassbauer, 12-16-2014 08:12 PM

block, common block, crank, crankshaft, harmonic balancer, pulley, trade, under drive

Replies: 1
Views: 1,477

Last Post By:: Last Post: 12-25-2015 03:49 PM; by markassbauer

Forum:
Parts For Sale

Custom intake plenum help

Started by Shredder, 12-16-2014 02:03 AM

2.5, block, body, boost, brake, brakes, common block, daytona, install, intake, parts, throttle body, two piece, vacuum

Replies: 2
Views: 1,602

Last Post By:: Last Post: 12-27-2014 03:14 AM; by turbovanman²

Forum:
Engine - Block, Piston, Heads, Intakes

weird coolant leak

Started by TheJ, 12-11-2014 04:31 AM

Replies: 16
Views: 4,827

Last Post By:: Last Post: 12-13-2014 12:04 AM; by cordes

Forum:
"I need help!"

Head Gasket Questions

Started by bamman, 12-10-2014 01:23 AM

1987, 2.5, 520, application, block, blue, chrysler, combo, cooling, cross, drill, engine, factory, front, gasket, head, list, manual, mopar, omni, parts, performance, service manual, turbo

Replies: 4
Views: 3,507

Last Post By:: Last Post: 03-30-2015 08:44 AM; by shadow88

Forum:
Engine - Block, Piston, Heads, Intakes

What is FUNATIC worth??

Started by funatic, 12-10-2014 01:07 AM

aem, block, boost, caps, chrysler, computer, convertable, exhaust, exhaust manifold, factory, free, front, gauges, le baron, manifold, oil, performance, pressure, rebuild, rods, swing valve, tii, transmission, vacuum, valve

Replies: 3
Views: 2,442

Last Post By:: Last Post: 12-10-2014 09:21 AM; by contraption22

Forum:
The Original "Turbo Dodge" Cars

Search:

Search: Search took 0.01 seconds.

Cooling Mod #4 question

Engine 2.2 Bare Common Block needed(w/mains)

2.2 LW rods - good for 220hp?

Engine 1992 Turbo III Engine Whole or Parts +.040 JEs Ti Retainers

My '92 Sundance refresh, rebuild, & conversion log

Engine Looking for a 2.5 turbo motor

TIII Center oil drain-back mod

ARP Head stud part number

Nitrous Experts - Please Advise

GLHS hybrid project, 10+yr build and counting

For Sale 1989 Plymouth Sundance Shell for parts, no title

Need help! Picture or explanation...pass side motor mount bracket, etc

Engine WTB 2.2 short or long block!

Big Block V8 Dodge Omni Build

Engine WANTED: Head, Turbo, Injectors, 3 bar MAP

Engine delete this thread please

piston expansion measurements

new Venolia forged pistons only $80 each + s/h??

Making my car more comfortable for long drives

forged piston question

Engine NEW under drive crank pulley

Custom intake plenum help

weird coolant leak

Head Gasket Questions

What is FUNATIC worth??