Search:

Tag: porting

Page 1 of 7 1 2 3 4

Search: Search took 0.00 seconds.

  1. Turbo Van Build

    Started by Jon411, 01-12-2021 05:52 PM
    2 Pages
    1 2
    5 speed, a568, air, big, cast, clutch, exhaust, fuel, fuel pump, gasket, head, injectors, intake, intercooler, lifters, list, manifold, porting, pump, tranny, transmission, turbo, turbo van, valve, van
    • Replies: 22
    • Views: 9,374
    Last Post: 08-16-2021 06:02 PM
    by cordes  Go to last post
  2. Prototype Two Piece Intake?

    Started by cordes, 08-30-2020 02:25 PM
    • Replies: 6
    • Views: 6,989
    Last Post: 10-06-2020 12:17 PM
    by Goforthz28  Go to last post
  3. 3D printing cylinder heads ???

    Started by bakes, 10-03-2019 08:48 PM
    3 Pages
    1 2 3
    block, cylinder, head, parts, porting
    • Replies: 48
    • Views: 53,104
    Last Post: 10-11-2019 01:22 PM
    by Reaper1  Go to last post
  4. TIII TIII head porting

    Started by Wastelands Warrior, 03-29-2019 11:53 AM
    head, porting, steve, tiii
    • Replies: 4
    • Views: 8,608
    Last Post: 04-05-2019 07:39 AM
    by Wastelands Warrior  Go to last post
  5. Lost another one

    Started by 135sohc, 03-18-2019 11:19 PM
    3 Pages
    1 2 3
    camshaft, control, cover, csx, cylinder, engine, exhaust, failure, head, intake, just my luck, key, original, porting, problem, roller, salvage, seats, swap, valve, valve cover
    • Replies: 43
    • Views: 64,663
    Last Post: 04-14-2019 09:53 AM
    by krut  Go to last post
  6. Head Porting

    Started by cordes, 02-17-2019 06:11 PM
    8 Pages
    1 2 3 ... 8
    • Replies: 157
    • Views: 103,525
    Last Post: 01-06-2024 11:57 PM
    by chromguy  Go to last post
  7. Cylinder head opinion

    Started by Dan H, 07-27-2018 12:44 AM
    • Replies: 3
    • Views: 2,046
    Last Post: 07-27-2018 12:50 PM
    by Dan H  Go to last post
  8. Sticky Thread Sticky: MPTune non Turbonator cals

    Started by wowzer, 03-11-2017 01:37 AM
    3 Pages
    1 2 3
    16v, 1990, aries, auto, cal, cals, ecu, glhs, masi, mopar, porting, smec, stock, thread, trans, turbo
    • Replies: 48
    • Views: 57,211
    Last Post: 06-30-2019 12:43 AM
    by cordes  Go to last post
  9. 4 hours of porting today, TU Header

    Started by 2.216VTurbo, 01-15-2018 12:50 AM
    6 Pages
    1 2 3 ... 6
    • Replies: 111
    • Views: 94,839
    Last Post: 05-03-2018 07:15 PM
    by GLHNSLHT2  Go to last post

    Forum:
    Exhaust

    • Replies: 8
    • Views: 3,664
    Last Post: 12-30-2017 11:47 PM
    by turbovanmanČ  Go to last post
  10. Two Piece Porting

    Started by cordes, 08-14-2017 12:08 AM
    7 Pages
    1 2 3 ... 7
    • Replies: 131
    • Views: 85,369
    Last Post: 03-15-2020 11:19 AM
    by ajakeski  Go to last post
  11. Ported Stockers Revisited

    Started by cordes, 07-27-2017 12:04 AM
    2 Pages
    1 2
    • Replies: 36
    • Views: 14,360
    Last Post: 03-17-2018 02:03 PM
    by cordes  Go to last post

    Forum:
    Exhaust

  12. Koffel 8v Head and IMSA ITB Setuo

    Started by CSX194, 07-31-2017 09:07 PM
    6 Pages
    1 2 3 ... 6
    • Replies: 107
    • Views: 35,649
    Last Post: 12-31-2017 12:42 AM
    by turbovanmanČ  Go to last post
  13. time for a chip.

    Started by masterjr33, 06-25-2017 08:26 PM
    2 piece, 5 speed, 5 speed., boost, fans, fuel, idle, injectors, intercooled, lifters, manifold, noise, porting, pump, smec, smell, stock, t2, timing, tu, tune, van, wet
    • Replies: 2
    • Views: 3,267
    Last Post: 06-26-2017 07:37 PM
    by 1BADVAN  Go to last post

    Forum:
    EFI Tuning

  14. Turbos/Intercoolers New Super 60 turbo and 2 piece lower

    Started by shackwrrr, 04-17-2017 12:58 PM
    .63, 2 piece, big, intake, mopar, original, porting, project, super 60, super 60 turbo, swingvalve, turbo, turbo 1
    • Replies: 4
    • Views: 2,503
    Last Post: 04-18-2017 07:01 PM
    by shackwrrr  Go to last post
  15. Power Lynz (Head Port/Polish Question)

    Started by enduro74, 02-23-2017 07:43 PM
    cylinder, fuel, head, intake, porting, power, valve
    • Replies: 5
    • Views: 2,574
    Last Post: 02-25-2017 09:45 AM
    by tryingbe  Go to last post
  16. Engine Ported +1mm 287 G head

    Started by moparzrule, 01-31-2017 12:28 PM
    • Replies: 7
    • Views: 10,129
    Last Post: 02-04-2017 07:17 AM
    by moparzrule  Go to last post
  17. Mild 2.5 build suggestions

    Started by BeeZnutZ1979, 11-12-2016 06:06 PM
    2.5, 2.5 turbo, a413, build, cal, daytona, drag, fuel, fuel pump, head, injectors, manifold, motor, performance, pistons, porting, project, pump, starting, swing valve, transmission, turbo, turbo 1, valve
    • Replies: 6
    • Views: 4,026
    Last Post: 11-13-2016 07:57 PM
    by Force Fed Mopar  Go to last post
  18. Cylinder head porting questions

    Started by GreatWhite, 11-09-2016 08:19 AM
    2.5, 2.5 turbo, air, cylinder, dakota, engine, exhaust, floor, head, intake, mph, oil, porting, power, turbo
    • Replies: 3
    • Views: 5,014
    Last Post: 11-09-2016 04:23 PM
    by 5DIGITS  Go to last post
  19. Shelby Lancer #79 1st Dyno results

    Started by turboshelbys, 08-14-2012 10:54 PM
    7 Pages
    1 2 3 ... 7
    • Replies: 124
    • Views: 42,197
    Last Post: 07-03-2017 01:21 PM
    by Reaper1  Go to last post

    Forum:
    Project Log

  20. General Solidworks models and silicone casts of swirl head!

    Started by acannell, 04-29-2016 07:19 PM
    application, base, cam, chrysler, for sale, forsale, free, head, intake, laser, porting, sale, scan, starting
    • Replies: 0
    • Views: 1,933
    Last Post: 04-29-2016 07:19 PM
    by acannell  Go to last post
    • Replies: 1
    • Views: 2,126
    Last Post: 03-17-2016 08:06 PM
    by Vigo  Go to last post
  21. 2.5 or 3 inch exhaust for Turbo Voyager?

    Started by ajakeski, 03-12-2016 10:20 PM
    2.5, 3 inch, exhaust, garrett, head, noise, porting, swap, turbo, voyager
    • Replies: 6
    • Views: 2,538
    Last Post: 03-13-2016 09:45 AM
    by ajakeski  Go to last post

    Forum:
    Exhaust

    • Replies: 2
    • Views: 1,681
    Last Post: 03-11-2016 01:10 AM
    by Fox  Go to last post
  22. 782 porting advise--valve guides

    Started by iangoround, 03-10-2016 01:12 AM
    • Replies: 12
    • Views: 5,189
    Last Post: 04-20-2016 12:27 PM
    by thedon809  Go to last post
Results 1 to 25 of 153
Page 1 of 7 1 2 3 4