Date: 27th January 2019
Username: DartGTS340
Full Name: Mark Robirds
City, State, Zip: Florence, MT
Complete IC kit with original instruction book. Both original mounting brackets in great shape. You have to mod the fuel rail so I'm including the already cut unit from an '84 with the big lines. Also that heat shield will come along. I long ago replaced the fiberglass with two stacked sheets of 3/16" mica board that I used to use to isolate heating elements in thermoforming molds. You can transplant them into a better shield.
The scoop is completely intact. never cracked, never repaired. Mounting studs are all still there. Three can wiggle but are still completely embedded with their anchor tabs. The rest are rigid.
people have mounted these an Omnis, mostly backwards facing installs. The bottom is usually reshaped heavily to accomplish this. The tapering of the base narrowing to rear in this case never looked right to me.
For those who have never been around one of these, the base is made to fit the center section of a 1st gen g-body. It follows its shape and form beautifully without any filler.
SOLD
Reply With Quote
