Ok just got my Shelby Daytona VNT on the road yesterday. Yesterday it ran great. Today on the way to work it stalled at a stoplight and was hard to start. Well got it started and kept wanting to stall. Had to drive around a bit and the same thing. Under a hard load like going up a hill. and moderate boost it bellows black smoke. And it ate alot of gas from what I think. So its running rich. Weird thing is it wouldnt blink codes. Light just stays on and when I start it then it goes off. I did find 2 wires that were chafed by a belt, I think they went to the injector harness, and I taped them up. So anyways I grabbed the DRB from work and ran dtc, I came up with this (sorry they dont give you the actual number like when it blinks) Auto shutdown x starts since set, o2 shorted to voltage, and injector 2 & 3 circuit control. Any ideas anyone? I am taking the DRB home so if anyone has any info like the map should be this voltage or injector pulsewidth should be this that would be great because I can read all that. The car just hunts at idle then stalls, and of course black smoke past mid boost going up a big hill. Thanks