I think I'll break down and put good braided lines on this time. Looking at the vendor sites, they have nice kits, but I'd like to use the fancy anodized fittings. So, what fittings will I need?
1.) Oil feed
From distribution block on front of engine its a, what? 3/8 NPT?? And is it the same on the on the turbo? (Garrett) Should be able to come straight out of the distributioin block and then a 90* into the turbo, right?
2.) Coolant feed
What fitting will screw into the head? What fitting will screw into the turbo?
3.) Coolat return
What fitting will screw into the back of the block? What fitting will screw into the turbo?
I could run to the shop and check all this out, but I figure someone here will have the knowledge.