36-1 Crank Trigger Rings $35

["Top Fuel" Bender]

Group Buy :

Pre-sale for 36-1 Crank Trigger Wheel (ring only)
Can deliver to SDAC/Carlisle
requires $18 deposit

is for the ring/wheel only
you will need to have it welded to your pulley
highly suggest having it turned after welding to true up the wheel
runout will be determined on how true your pulley runs

Please specify
'84-87 Non-Common Block


'88 Only


'89-up Common Block




Have not tried on the TIII serpentine setup yet

[cordes]

Are the pulleys the same regardless of if it's an AC pulley or not?

["Top Fuel" Bender]

these mount to the A/C part of the pulley but won't interfere with running an a/c belt if mounted flush on the belt side
good thought on the early cars or those that modify the pulley

["Top Fuel" Bender]

Are the pulleys the same regardless of if it's an AC pulley or not?

NOW AVAILABLE for NON-A/C Pulley
36-1 trigger wheel ring will need to be welded to the water pump/alt section of the pulley. If you already ordered the standard trigger wheel and would like the non-a/c version lmk and I can swap them out for you.

[Chattownguy]

I sent you a long rambly, potentially drunken pm the other day lol but haven’t heard back so was wondering how can I go about ordering one of these bad boys? For an 89 with a/c.

[MGeyer]

If these are still available, I'd like to have one. I've got an 86 Turbo Z with a 2.5 CB T2 setup with 88 SMEC in it with Ostrich & MPScan(??). I'm struggling with trying to figure it out, so was thinking of pulling the whole bit off and starting fresh with a Micro/Mega squirt system.
Thanks,
Mike

[cordes]

I now have one of these running a car. Joy's Daytona has one of the non-common block A/C pieces installed and working well. I gambled and installed it at about .015 on the tight side, and there's not enough runout to cause a loss of sync. This was a super easy install and I would highly recommend it if a guy wants to roll his own.

[canon1753]

Can I order one for a non common block 84-88 2.2? Also, what do we do for brackets? I’m going to be weird and do a no turbo 2.2

[cordes]

For the non-common block I made my own bracket. I've modified the design slightly since the video was produced, and it's much easier to make now. I've been very happy with it.

[canon1753]

Neat! I couldn’t do that.