Good evening,
I am in the middle of a very long head gasket job...actually the gasket was fine, I pulled the head to check the turbo because I thought it was burning oil. Turns out it's probably bad valve seals. Anyway, I pulled the head sometime in August. I have worked on it little by little here and there. Yesterday, I went into the unheated garage to find the two middle cylinder walls (piston 2 and 3 at BDC) have flash rusted. So I put some engine oil on the walls to stop any worse damage. I don't want to use steel wool for fear of some of the steel wool staying in the cylinder and causing more damage. What should I do?
Lee
86 Turbo Z 2.2