MPScan wont record

[jeff1234]

My MPScan wont run, this text message is generated by MPscan. Can anyone tell me why it wont switch to the high speed baud setting?




mpscan ver - 2.0.5.2 (09/06/2021 7:11:13 AM)
Microsoft Windows 10 Home - Win32NT
trying to open port COM3 - ctlrecord_click
got a good port back - ctlrecord_click
try to open port COM3 -initport
COM3 is a legit port -initport
usb is available on COM3 -initport
usb ftdi serial number FT3FDXXK is available - initport
[usbportinit] setting port baud rate to 976
ftdi open successful on COM3 -usbportinit
using protocol LM:0
attempt to change ecu baud rate to 7812
Send byte 0x12 (18d) three times to change the ecu to high speed mode.
Sending byte 18
Received 0 byte(s): 0
Sending byte 18
Received 0 byte(s): 0
Sending byte 18
Received 0 byte(s): 0
Changing mpscan baud rate to 7812
Sending byte 18
Received 0 byte(s): 0
Sending byte 18
Received 0 byte(s): 0
Sending byte 18
Received 0 byte(s): 0
Sending byte 18
Received 0 byte(s): 0
usbsethibaud failed - usbportinit
ftdi open unsuccessful - usbportinit
Sending byte 254
Received 0 byte(s): 0
Sending byte 254
Received 0 byte(s): 0
can't open ftdi port - -initport
Unable to open/setup port. - ctlrecord_click

[jeff1234]

I found a broken wire. Problem solved.

[chromguy]

Awesome, great news