Hello everyone. I have a 1990 Dodge Shadows that last year I fixed a broken lug going to the alternator. It seems to be working fine as the engine would start and pur very nicely and battery stayed charged. It had a couple of gas lines leaks that have since been repaired. Then I needed to fix the no pressure brake system and that is where this problem began.
I now have zero electrical going through the system. No dash, no lights, no wipers, no horn, no turn signals, dome light hasn't worked for years but I think it was due to no fuse, and the radio got stolen a few years ago and never replaced. Sometimes I'll get the open door chimes but not always. The battery keeps getting drained but will charge and maintain voltage as long as it's not hooked up and is about 1 year old.
Upon looking around I found a grounding wire lying on top of the valve cover next to the carburetor. The other end is bolted securely to the chassis. I have no idea where it's suppose to go. The only thing close is the power steering. I also found a nut next to it as well. I can't find a bolt or anything where this is suppose to go to.
In the past the dashboard lights along with the taillights will blow the fuse sometimes and go out. Sometimes it won't blow the fuse but just go out. If I turn the engine off and wait about 20-30 seconds and turn it back on most of the time they come back on. I've put as large as a 30am fuse in and it still gets blown. I don't know if the problems are connected or not but there is definitely a short. I've replaced the pull knob for the headlights and that has not fixed the dashboard light problem.
I have the original Chrysler repair manuals but I'm not a mechanic and currently out of job so having someone else fix it isn't an option right now. One thing the manuals do not show is where some of the relays are located. They show me this triangular shaped base that 3 cube relays plug into and one sounds very important. I can't find it in the engine compartment and it's certainly not inside where the fuse panel is located.
I picked up a relay tester to check those relays but getting rather mad that the manual gives zero indication where to find it. I've found the other ones but they are not the usual relays. They have wires feeding into the bottom and then plug into a cap. I need to fix the bulb on my tester but my question is if one of those are bad how do I replace it? Do the wires just pull out or do I need to splice them in with a new one.
The car is a 2.2 L non turbo with AC body style AP. I'm not able to post pictures otherwise I would upload the 2 photos I've taken.
Reply With Quote
