I have a compressor housing that I was told is for a super 60 turbo. Does anyone have any measurements I can use to check it. It's a garrett housing so likely to have been machined to accept the super 60 wheel if it is.
I have a compressor housing that I was told is for a super 60 turbo. Does anyone have any measurements I can use to check it. It's a garrett housing so likely to have been machined to accept the super 60 wheel if it is.
Well if you have a s-60 compressor wheel does it fit over the cover? No way will a standard t3 50 trim compressor cover clear the s-60 wheel. BTW the REAL MP s-60 compressor covers were polished. The S-60 compressor inducer diameter is 1.900", while the standard 50 trim compressor inducer diameter is 1.674" That is a big enough difference to see with naked eye without measuring.
Hope this info helps,
Todd
Measure the ID of the compressor inlet.
1.9 = S60 like Todd said.