Results 1 to 2 of 2

Thread: Oil pickup o-ring

  1. #1
    Supporting Member Turbo Mopar Contributor
    Join Date
    Feb 2015
    Location
    toronto
    Posts
    1,765

    Oil pickup o-ring

    I needed an o-ring and the "standard" 117 o-ring in my opinion was a poor fit but I am not an oring expert.
    The best ring I tried is a 20mm ID 2.5mm cross section.
    The best install procedure is to install the oring in the groove and then insert the pickup with a slight twisting motion. Any other method will pinch the oring.
    Thanks to Bradd aka DoubleD for the calculations
    Regards,
    Miles

    DD '87 Sundance T1, SLH with rear disks
    '87 CSX #432 2.5 CB TII, SLH

  2. #2
    turbo addict
    Join Date
    Mar 2014
    Location
    Toronto Canada
    Posts
    1,772

    Re: Oil pickup o-ring

    have you got an old gasket kit kickin' around the garage.. there should be an oil pump O ring in any gasket kit

Similar Threads

  1. Engine CB 2.5 oil pan + pickup
    By thedon809 in forum Parts Wanted
    Replies: 0
    Last Post: 12-05-2014, 02:33 PM
  2. Where to get o-ring for oil pickup screen?
    By jefo in forum Engine - Block, Piston, Heads, Intakes
    Replies: 3
    Last Post: 08-27-2012, 01:08 AM
  3. Ring material pro's and con's, steel top ring vs cast ring?
    By turbovanmanČ in forum Engine - Block, Piston, Heads, Intakes
    Replies: 10
    Last Post: 04-29-2011, 05:02 AM
  4. Ring gap questions for the 2nd ring! This should be good.
    By turbovanmanČ in forum Engine - Block, Piston, Heads, Intakes
    Replies: 22
    Last Post: 01-14-2011, 06:23 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •