Help Needed 1989 Daytona
Trying to figure out what fasteners are used for attaching the front bumper cover to the fascia panel?
Thanks!
Help Needed 1989 Daytona
Trying to figure out what fasteners are used for attaching the front bumper cover to the fascia panel?
Thanks!
Last edited by Livnitup77; 01-07-2021 at 10:32 PM.
Can someone look on their car to see if these should be bolts or plastic retainers/rivets? Pictures would be of help as well.
Thank you!
Sent from my iPhone using Tapatalk
the top filler panel between the fascia and rad cradle is held in with plastic Christmas tree fasteners,, there also should be two metal rivets holding the two pieces together in the center
if needed,
the side areo pieces , I have the plastic top attachment strips and the metal lower replacement rails , nos if needed
(fender doglegs , doors and front of rear quarter panels)
I do not have the metal retainer strips that hold the sides of the bumper covers to the front half of the fender or rear of the Q pannels
Thank you for the response! I’ll take a look to see if I need any additional parts and send you a message. Thanks again for the info!
6501067 14 RETAINER, Bumper Fascia to Reinforcement (one inch head)
6030441 12 RETAINER, Sight Shield (11/16 head)
6031390 8 RETAINER, Bumper Fascia to Fender (one inch head)
# after the part # is the QTY used
I have all of these used or NOS