This is regarding the SMEC in my lancer. I was lazy and grabbed a bK/green tracer wire and spliced in the 0-1v NB output from my WBO2 controller to feed the computer the signal. Only problem was that there are two black with green tracer wires in that area. I grabbed the one for the knock sensor instead of the O2 sensor signal. Will feeding a DC 0-1V signal to the knock sensor signal wire destroy that portion of the board? I'm getting very little knock voltage out of the computer now. It is .02V unless I really let a 1/2" drive extension rattle the intake. There were a couple times I did get some knock voltage when in boost, but it really didn't pull timing.

I did check the continuity from the knock sensor to pin #2 on the SMEC and it is great.

On the up side, the car is making more power at the same boost. The clutch is now slipping after my upgrades including a ported head and exhaust manifold, TII intake, and S60 IC. Ups and downs here I guess...