Results 1 to 12 of 12

Thread: replacing injector drivers in SBEC/2

Threaded View

  1. 12-06-2019, 12:53 AM #1
    chromguy
    chromguy is offline
    Supporting Member Turbo Mopar Contributor
    Join Date
    Feb 2015
    Location
    toronto
    Posts
    1,767

    replacing injector drivers in SBEC/2

    Have you replaced injector drivers in your SBEC or SBEC2?
    I developed an easy procedure to get them off the board that I will write up shortly.
    First does any one know what to replace these with.
    They appear to be a 5 pin TO-220-5 MOSFET of some sort. Is something for peak and hold?
    The V6 uses a standard TO-220-3, the 3 pin N-channel MOSFET. I was able to identify this with my "transistor tester" with a Vgs of 1.4V
    Last edited by chromguy; 12-06-2019 at 01:07 AM.
    Regards,
    Miles

    DD '87 Sundance T1, SLH with rear disks
    '87 CSX #432 2.5 CB TII, SLH
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. SBEC injector drivers
    By Dan H in forum EFI Tuning
    Replies: 8
    Last Post: 07-31-2019, 10:26 AM
  2. Repairing/adding drivers in SBEC/2
    By chromguy in forum Electrical & Fuel System
    Replies: 0
    Last Post: 03-23-2019, 07:57 PM
  3. SBEC injector strategy question
    By 85lebaront2 in forum Electrical & Fuel System
    Replies: 7
    Last Post: 01-25-2019, 03:32 PM
  4. Electronics 2.5 t1 sbec injector harness
    By thewraith1971 in forum Parts Wanted
    Replies: 10
    Last Post: 10-19-2011, 08:55 PM
  5. Has anyone repaired the injector drivers in a SMEC ?
    By butchsuppe in forum EFI Tuning
    Replies: 6
    Last Post: 07-25-2009, 02:41 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules