Is it possible to replace the exhaust manifold gasket on a t3 motor without removing the turbo?
Is it possible to replace the exhaust manifold gasket on a t3 motor without removing the turbo?
I know it's possible, at least with the engine out of the car. I'm sure it's doable with it in the car, but difficult. I have a turbo on a TIII manifold that I can't get the nuts to break loose, so it can be done.
“If the people of the nation understood our banking and monetary system, I believe there would be a revolution before tomorrow morning.” -Henry Ford
The entire manifold/turbo combo can be removed while the motor is still in the car, but it is a lot more difficult to do it this way. If you are going to attempt this, make sure to remove the front motor mount and rear bobble strut and loosen the passenger side mount so you can rock the entire motor forward a few inches. You'll be thankful for the extra room.
~Tyler Larsen~Salt Lake City~
-92 Daytona R/T (T3/T4 Hybrid, Quaife, etc...)
-86 Jeep Grand Wagoneer Woody (winter beast)
-01 Audi TT Quattro (daily driver)
-71 Plymouth Cuda 440-6pk tribute
Check out my Homepage