Results 1 to 3 of 3

Thread: Transmission output spline sizes

  1. #1
    Supporting Member II Turbo Mopar Contributor jeff1234's Avatar
    Join Date
    Mar 2006
    Location
    Albany Wisconsin
    Posts
    1,010

    Transmission output spline sizes

    Is it correct to say that there are two sizes of output splines for all of the manual FWD transmissions? or are they all the same size?
    Last edited by jeff1234; 03-03-2019 at 10:11 AM.
    The only substitute for cubic inches is cubic dollars, how fast can you afford to go?

  2. #2
    turbo addict
    Join Date
    Mar 2014
    Location
    Toronto Canada
    Posts
    1,772

    Re: Transmission output spline sizes

    2 sizes of axle splines used .. for all transmissions , manual AND automatic large spline starts in 87

    EXCEPT the manual omni's after 87-9 (all still 525 trans , small spline)

    this is why you use the late model omni auto axles to put a 520,555,523,568 trans in an omni or charger

  3. #3
    Supporting Member II Turbo Mopar Contributor jeff1234's Avatar
    Join Date
    Mar 2006
    Location
    Albany Wisconsin
    Posts
    1,010

    Re: Transmission output spline sizes

    The Dr. Is in! Thanks much Dr. "J"
    The only substitute for cubic inches is cubic dollars, how fast can you afford to go?

Similar Threads

  1. General WTB: Heat & Transmission Shields/ Large Spline Clutch & More
    By bobintrees in forum Parts Wanted
    Replies: 1
    Last Post: 06-08-2016, 09:08 PM
  2. Transmission 1991 568 large spline transmission (Cliff Ramsdell rebuilt)
    By layapatch in forum Parts For Sale
    Replies: 0
    Last Post: 03-03-2015, 12:26 PM
  3. A413 output gear size, speed/ratio at output shaft?
    By RoadWarrior222 in forum Transmission
    Replies: 4
    Last Post: 09-23-2012, 01:11 PM
  4. Transmission output shafts, excessive spline wear
    By 135sohc in forum Other vehicles
    Replies: 0
    Last Post: 11-17-2010, 03:44 PM
  5. Transmission Trade small spline disk for large spline disc
    By moparfreak3 in forum Parts Wanted
    Replies: 3
    Last Post: 03-06-2009, 11:34 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •