Results 1 to 6 of 6

Thread: SBEC2 V6 vs T1

Threaded View

  1. #1
    Supporting Member Turbo Mopar Contributor
    Join Date
    Feb 2015
    Location
    toronto
    Posts
    1,766

    SBEC2 V6 vs T1

    It is known that V6 SBEC2 can be rechipped to run a 2.5 TBI. My quest is to determine if it can run a TII
    Most of my SBEC2 V6 use PCB board, 4517652 which is the same PCB and Logic chips as my FWD Stage 5 SBEC2. The same PCB and drivers chips also used in a SBEC2 MPI(??) that I have B4639557, this may be an easy conversion. Just Rechip???? Edit: B4639557 is missing two of the Driver chips under the heat sinks so it is unlikely MFI as was listed on the hand written label. The board is also missing a few minor components.
    I have noticed a dozen or so passives smd component that are different on the V6 vs Turbo. I will document the differences and post.
    Last edited by chromguy; 02-18-2019 at 12:56 AM.
    Regards,
    Miles

    DD '87 Sundance T1, SLH with rear disks
    '87 CSX #432 2.5 CB TII, SLH

Similar Threads

  1. Identification of SBEC vs SBEC2
    By chromguy in forum Electrical & Fuel System
    Replies: 17
    Last Post: 04-05-2019, 08:38 PM
  2. how to tell SBEC from SBEC2?
    By chromguy in forum Electrical & Fuel System
    Replies: 0
    Last Post: 12-25-2017, 12:16 AM
  3. Electronics 92 -93 2.5 ti sbec2
    By Xtrempickup in forum Parts For Sale
    Replies: 0
    Last Post: 11-18-2014, 01:25 PM
  4. Engine 92 Spirit 2.5TI SBEC2 and harness
    By Xtrempickup in forum Parts Wanted
    Replies: 0
    Last Post: 06-08-2009, 11:51 AM
  5. Convert from Sbec2 to Sbec 1
    By Xtrempickup in forum Electrical & Fuel System
    Replies: 9
    Last Post: 02-20-2009, 11:01 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •