So trying to order new bearings for this motor I am putting back together for my kid. Just going to give it a quick 600 grit polish.
Connecting rod Journals measure 1.963".
All data I'm seeing for bearings is showing a stock nominal size of 1.9687 max and 1.9677 min
So by my calculations this is about 0.005 undersized. Or 0.127mm
The only bearings I'm seeing on rock auto are .25, .5 or .75mm.
What am I doing wrong?
This engine shows no signs of ever being rebuilt.
Its a 91 Common block 2.5 T1.
There is a 10-1X mark on the bearings and cap side has B-7 rod side has A-8.
If I can't figure this out it's just polish the journals with 600 grit and leather and toss the old bearings back in.
Thanks for any insight.