I have an 89-90 stamped arm crossmember, can I use the 91+ cast arms on this crossmember?
Thanks!
I have an 89-90 stamped arm crossmember, can I use the 91+ cast arms on this crossmember?
Thanks!
Regards,
Miles
DD '87 Sundance T1, SLH with rear disks
'87 CSX #432 2.5 CB TII, SLH
They should bolt right in. I've made the swap from later arms to earlier arms with no problem. I believe the only issue would be with the later, larger Dynasty and 5th Avenue. Those cars with the heavier axles had a different K frame and arms from what I've read.
Dynasty has the same k frame (minus the bobble strut bracket). Arms and knuckles are different.
Thanks Gentlemen.
Regards,
Miles
DD '87 Sundance T1, SLH with rear disks
'87 CSX #432 2.5 CB TII, SLH
I looked it up and they showed different part number IIRC. The k frame was the same part number as all the other automatic k car k frames. I'm putting a dynasty dual pivot k frame in my lancer.
This is an 89 or 90 dynasty k frame with arms from a lebaron or p body. Can't remember. Has energy suspension bushings. Working on drilling + tapping my stock 87 SL sway bar for end links.
According to the ever reliable Wikipedia, there was a wheelbase change in 91. That's probably when they used the different arms.
https://en.wikipedia.org/wiki/Dodge_Dynasty
In the knowledge center there is a write up on the crossmember and control arms. There seems to be a small difference. Check it out