I may be able to meet you in Champaign. What day would you be able to meet up when you are there?
I may be able to meet you in Champaign. What day would you be able to meet up when you are there?
Shoot me a PM when you're free after this week. I'll be on break until early January.
In for cheaper shipping!
Brent GREAT DEPRESSION RACING 1992 Duster 3.0T The Junkyard - MS II, OEM 10:1 -[I] Old - 11.5@125 22psi $90 [U]Stock[/U] 3.0 Junk Motor - 1 bar MAP [/I] 1994 Spirit 3.0T - 11.5@120 20 psi - Daily :eyebrows: Holset He351 -FT600 - 393whp 457ft/lb @18psi 1994 Spirit 3.0T a670 - He341, stock fuel, BEGI. Wife's into kid's project. 1990 Lebaron Coupe 2.2 TI/II non IC, a413 1990 Spirit 3.0 E.S. 41TE -- 1993 Spirit 3.0 E.S. 41TE -- 1994 Duster 3.0 A543 1981 Starlet KP61 Potential driver -- 1981 Starlet KP61 Parts -- 1983 Starlet KP61 Drag 2005 Durango Hemi Limited -- 1998 Dodge 12v 47re. AFC mods, No plate, Mack plug, Boost elbow -- 2011 Dodge 6.7 G56
Any left. I need one badly. Im going to build a T2 for my newly purchased 95' Lebaron. Sounds like you might have a few parts I need. I need a fuel rail, injectors, 90+ wiring harness, 90+ turbo SBEC, turbo connecting rods, turbo valve cover knock sensor.....
So far I have a block, pistons, complete head, exhaust manifold, bov, turbo piping and complete tranny.
I know harness and sbec are hard to come by so if I can' t find them I'll have to go standalone but don't want to if I don't have to.
Any help is much appreciated.
Just realized you live just a little bit north west of Terre haute.
I updated the OP with the following information.
I sent off two of them in a box to MN yesterday, and it was about $41. It seems like box size determines cost more than anything from what I can tell. I have four of these left.
It's more work than it is worth to try to give parts away around here.
I would agree. However, I think the guy I just sent two of these to really appreciates it. I would rather have them sit in my basement than go to scrap, but I would rather they go away for free than sit in my basement. It's rough.
I and another guy here are in need of fuel rails (one each) for one piece intake..
I thought I had one but the end's bent over from when I moved
not looking for free so much as looking for .. parts
(I can't port my two piece for my "build" motor if I use it just to convert a stock one to TII)
I'm also looking for a busted two piece bottom - something fubar behind the fuel rail bolt holes
I'm not sure that I have any more good one piece rails. I'll have to check my garage when I'm out there next. I think I gave my last nice one away when I sent off a couple intakes to someone.
OK , Thanks