I came across this for a Volvo and it seems it can be easily adapted to a Dodge distributor?
https://yoshifab.com/store/billet-re...s-adapter.html
Then you can go aftermarket ECU with sequential injection with COP.
I came across this for a Volvo and it seems it can be easily adapted to a Dodge distributor?
https://yoshifab.com/store/billet-re...s-adapter.html
Then you can go aftermarket ECU with sequential injection with COP.
I actually have provided an adapter for the 420a/SRT4 engine...
http://rbryant.freeshell.org/420a_cam_adapter.htm I have a couple of them in stock.
The guy made over 700hp on the dyno which is/was the record for a 420a using my adapter.
Some of his videos show the prototype version where the bolt holes were slightly misplaced so it was rotated past the slot in the DSM sensor (this is now fixed).
https://youtu.be/fDdIjWpBgWA
-Rich
Offering Custom/Niche FWD Dodge Products!
- 91+ 11" HAWK HPS/LTS Front Brake pads @ $30/1 or $55/2 sets Half Off MSRP of $70
- Custom MSD Spark Plug Wires and improved Dist Caps
- BC Racing Coilovers
- OBX LSD Rebuild Parts
- DOHC 2.0/2.4/Hybrid products
- Solid Aluminum Alternator Brackets, Holset Turbo Flanges, and Wheel Spacers
Main Products/Info/Sales Webpage
Nice! If there is a demand, what do you think the price point would be for an adapter for the 2.2/2.5 distributor position?
Will the DSM CAS fit on a 2.2/2.5 directly centered over the stock distributor drive shaft in place of the distributor? This is with the distributor shaft cut down to be below the surface of the distributor base where the HEP mounts.
If it will then it would be pretty easy, if not then it would be difficult.
-Rich
Offering Custom/Niche FWD Dodge Products!
- 91+ 11" HAWK HPS/LTS Front Brake pads @ $30/1 or $55/2 sets Half Off MSRP of $70
- Custom MSD Spark Plug Wires and improved Dist Caps
- BC Racing Coilovers
- OBX LSD Rebuild Parts
- DOHC 2.0/2.4/Hybrid products
- Solid Aluminum Alternator Brackets, Holset Turbo Flanges, and Wheel Spacers
Main Products/Info/Sales Webpage
I don't know, someone else will have to figure it out as I don't have a CAS.
This 1.6 Miata I have here uses a similar setup. It even has the Mitsubishi logo on the CAS.
Check this out.
http://projectzerog.com/forum/viewto...461ead03cd29eb