Date: 17th September 2018
Username: shelbymopar89
Full Name: Brent Duvall
City, State, Zip:
Contact: BrentDuvall@gmail.com
Selling or Wanted Price: $10,000
Description: 1989 Dodge Daytona Shelby.
Delivery possible.
Fleming Ohio. 45729
Time for a new toy, I have put 138 miles on this in the past two years. Only known issues are the T-top driver side will drip in the rain and the drivers side driveshaft is still a tad too long. Never notice it during most normal driving, but when pushed hard in a right hand turn you can feel it. They are Drive Shaft Shop axles and I never sent it back to get it shortened. I have been driving it for 8 years without any issues, but if you wanted to corner like crazy it would be. I think I also have a lower ball joint going out as I hear a pop in the front from time to time. I have a pretty recent carafax and it is flagged for the milage. When I restored it I put a new dash in it, I still have the old dash to go with the car. PIC LINK BELOW.
ENGINE AND DRIVETRAIN
Block
0.040-over stock 2.2
Wiseco pistons Skirts/top coated
All ARP Hardware
Cylinder Head -Done by MRPbody ported, oversized valves
Cometic Head Gasket
ARP Studs
Camshaft
Roller
Fidanza Adj
Intake Manifold
Ported one peice
Vac block
Alum Fuel rail
T.U. 3 core radiator
Throttle Body
52mm
Turbo
Turbonetics T3/4 50 trim Stage 2 Wheel
Spearco 1080
Turbo XS Boost Ctlr
Tial BOV
Exhaust
F.M. Stainless 3 inch mandrel bent
T.U. 3 inch S.V.
T.U. Stainless Header (coated)
Fuel System
+40's
Walbro 255 pump
Accufab A.F.P.R.
Earls lines with all AN fittings
All new lines brake/fuel
New gas tank/sending unit/fuel pump mount
Transmission
A555 with 5K orig miles on it, polished.
Mcleod Rev-loc
Purple plate
Chrome Molly end plate
Quaife LSD
Level 2 axles- THE DRIVESHAFT SHOP
Engine Managment
Stage 5 Cal
3 Bar Map
3 Bar progressive Devils Own Alky Inj DevilsOwn alcohol water injection
MSD Blaster coil
Magnacore wires
Gauges
The following are Auto Meter Ultra lite series
Boost 0-30
EGT
Water Temp
Elect Fuel Press
Oil Press
Innovate LC-1/XD-16 Wideband
Suspension and Chassis
Every bushing that Johnny makes is in this car
Custom Koni front and rear Adj coil overs
Brakes
S/S Sraided Lines
Carbotech, Bobcat pads
All new brake lines
Rebuild of my power steering unit- steerandgear
Chassis stiffening
Front strut tower brace
Rear swaybar
ADJ Panhard bar
https://drive.google.com/drive/folde...Zvem8?ogsrc=32
Reply With Quote
