Results 1 to 3 of 3

Thread: recommended sealant type

  1. #1
    Supporting Member Turbo Mopar Contributor
    Join Date
    Feb 2015
    Location
    toronto
    Posts
    731

    recommended sealant type

    While repairing my CSX, I noticed a foam like sealant was used between the inner fender and the firewall. I was planning to use Napa seam sealant, it claims to be recommend in high vibration areas such a wheel wells etc. My FSM say that sealant is important but does not go into more details.
    Regards,
    Miles

    DD '87 Sundance T1, 12PSI, SLH with rear disks
    Project '87 CSX #432
    Donor car '88 Daytona Shelby Z, TII with S60 Turbo/smec, 3 bar.

  2. #2
    Supporting Member II Turbo Mopar Contributor
    Join Date
    Jan 2006
    Location
    Everett, WA
    Posts
    6,242

    Re: recommended sealant type

    I think it's an closed cell epoxy foam. Most likely used for sound proofing and sealing. I make sure there's no rust then use regular seam sealer to seal it up again.

  3. #3
    Supporting Member Turbo Mopar Contributor
    Join Date
    Feb 2015
    Location
    toronto
    Posts
    731

    Re: recommended sealant type

    Quote Originally Posted by Reaper1 View Post
    I think it's an closed cell epoxy foam. Most likely used for sound proofing and sealing. I make sure there's no rust then use regular seam sealer to seal it up again.
    That is exactly what I did earlier today. The good news is there is nearly Zero rust on this baby!!!
    Thanks for the advice
    Regards,
    Miles

    DD '87 Sundance T1, 12PSI, SLH with rear disks
    Project '87 CSX #432
    Donor car '88 Daytona Shelby Z, TII with S60 Turbo/smec, 3 bar.

Similar Threads

  1. sealant on headgasket?
    By csx452 in forum Maintenance & General Tech
    Replies: 27
    Last Post: 02-20-2011, 12:37 PM
  2. Thread sealant?
    By chad_m in forum "I need help!"
    Replies: 11
    Last Post: 01-20-2010, 01:59 PM
  3. intake sealant?
    By W.P._Turbocars in forum 3.0L V6 Turbo Engines!
    Replies: 15
    Last Post: 06-19-2009, 12:39 PM
  4. Adhesive / Sealant?
    By shelbydave in forum Interior & Exterior Restoration
    Replies: 2
    Last Post: 04-03-2009, 03:04 PM
  5. Recommended IC setup
    By Devsdaytona in forum Engine - Block, Piston, Heads, Intakes
    Replies: 10
    Last Post: 02-13-2007, 12:54 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •