looking for 88-89 turbo engine harness from a daytona, lebaron, shadow, newyorker etc. not from a minivan. (already have a 89 minivan turbo engine harness)
preferably around 100$
thanks
Brian
looking for 88-89 turbo engine harness from a daytona, lebaron, shadow, newyorker etc. not from a minivan. (already have a 89 minivan turbo engine harness)
preferably around 100$
thanks
Brian
Originally Posted by turbovanman
I think I have a 89 turbo shadow / manual trans harness. Bumper to bumper. I’ll see if I can dig it out.
have you seen an 88 K car smec harness?
it still used the bulkhead connector at the firewall - NOT the rubber gromit like the other 88's started doing
and fyi - IF you swap to the rubber gromit in the firewall the round hole you need to make is the same diameter as the square hole - IF you measure the square hole diagonally corner to corner
so essentually you need ro remove a D shaped piece on each side of the square 50 way bulkhead connector hole
I can get u one from a stock 88 lebaron T1 auto, complete harness.
I have a 88 turbo z I'm going to be parting out. I want to sell the engine first as I would like to show the possible buyer that the engine runs. If you don't need it ASAP I could probably help you out.
Sent from my XT1254 using Tapatalk
i wanna try my LM to SMEC conversion first. so no rush. each of you, lemme know how much for each harness shipped to 14569. PM is fine. thanks.
honestly, i like the idea of keeping the SMEC logic board in the passenger compartment even if the battery temp sensor isnt seeing the correct temp. for using an ostrich and preventing the SMEC logic board socket area from being exposed to water, the passenger compartment is great. i may use some wire to extend the battery temp thermistor from the board to near the battery for accuracy..
Brian
Originally Posted by turbovanman
I can get n sell u the complete lebaron onw for $125 shipped including all the solenoids n relays n sensors that are connected to firewall n strut tower/fender walls. Even include the fuel injector clips.
I have a harness from an 89 LeBaron 2.5 turbo I auto car. $100 shipped.
Sorry Brian, it's a 88 2.2 auto t1 convertible 2 dr lebaron
I've got an 88 J body harness that I had started to add a charge temp wire to. Are you coming to SDAC?
almost done with my 87 LM harness to SMEC conversion. if it doesnt work as expected, ill get back to you guys.
no im not going to SDAC this year.
thanks
Brian
Originally Posted by turbovanman