26th September 2017:
Bardo:
AJ Lombardo:
Mather, PA 15346:
7two4-4six9-003two:
$1,200:
1986 Dodge Lancer ES for sale.
The good.
Acufab afpr, 52lbs per hour injectors. The top-end is from a glhs so its a Two-piece intake manifold with Garrett T2 Turbo held down with ARP head studs. 2.5 bottom end .02 over forged Wiseco pistons, T2 shot peened rods from fwd performance with ARP broad bolts. The block was hot tank and magnafluxed before reassembly with new bearings and freeze plugs. This was all done less then 200 miles ago.
413 automatic just hit a fluid and filter change.
Lc1 wideband, 89 mini wiring harness with socks smec running an ostrich emulator. The cable for the emulator as well as the data cable for MP scan ran into the driver's compartment next to the laptop mount. Manual boost controller lines ran inside so you can adjust the Boost from inside the car. The only rust on the car is the two small holes I took pictures of, all the quarters and rocker panels are clean.
Now the bad.
The car doesn't run. I was going to load on a trailer to take it to the racetrack and I couldn't get it to start. There is an electrical problem somewhere in the car and I'm tired of looking for it. No fuel or spark but it will turn over. Unfortunately the car is also ugly and had very little interior. The black stuff in the last picture around the hole is where I remove the seam sealer.
The car comes with lots of extra parts like another 2.5 out of a caravan and an extra 413 transmission. I also have a Lancer Shelby that we can possibly negotiate Parts off of.
Asking $1,200