OK, quick question for all you SMEC guru's out there. Pin 29 on the 60 way connector is an input from the brake switch. According to minimopar resources, it's just a 12V input to the ECU so the computer knows when the brake is applied. The ECU raises idle speed until the speed sensor tells it the car is about stopped. It's also used to cancel cruise(which I don't have). On the SMEC cars, there is a second set of contacts on the brake switch that this goes to. Is there any reason I can't just tie into the brake signal wire? My 83 doesn't have the second set of contacts on the switch.
I just don't want to fry anything on this build.
Thanks in advance for the help.