Can the white wire (0-5V) from this controller be used as a substitute input for the stock O2 sensor? If the answer is yes, is there any benefit to doing this mod?
Thanks!
jeff
Can the white wire (0-5V) from this controller be used as a substitute input for the stock O2 sensor? If the answer is yes, is there any benefit to doing this mod?
Thanks!
jeff
The only substitute for cubic inches is cubic dollars, how fast can you afford to go?
Not with the LM since I last checked. I think Rob had the SMEC or SBEC set up to use the charge temp sensor input to do that.
There is a switch in the back UEGO that allows the user to select to different type of output, 0-1 is one.
Read the manual.
Now, I've done the 0-1v output to the module from a PLX unit before. That worked well IMO
Switching the scale would change my gauge readout I think. I am unfamiliar with the acronym PLX.
The only substitute for cubic inches is cubic dollars, how fast can you afford to go?
I did read the manual, but isn't it is wise to defer to those who know better? I thought that is why this website exists!
The only substitute for cubic inches is cubic dollars, how fast can you afford to go?