Hey guys, I'm pretty close to getting the engine into my Daytona, swapping a '98 Dodge Grand Caravan Sport 3.8L and 41TE into a 1989 Dodge Daytona ES. I was wondering if I could just bolt the wheel hubs onto Daytona knuckles? I haven't looked at the axles closely to see if they will mate up anyway, I was just wondering if this was a possibility. I know a '90 Daytona hub and early 41TE have the same spline count. But I doubt the later van ones do, as the axles look much beefier.


Just wondering, otherwise I'll just make some hybrid axles.


Thanks!