So I bought the latch board for the smec with chip. I am wondering does the board matter what direction it is soldered in. Does the eprom go in a certain way. I searched and not found much of install direction
So I bought the latch board for the smec with chip. I am wondering does the board matter what direction it is soldered in. Does the eprom go in a certain way. I searched and not found much of install direction
Yes, there is a notch at one end, needs to face the same way as the factory one.
It is the smec
It is the smec and sorry it is the socket the the chip goes on
I'm confused. You don't need a latch board for a SMEC. In fact, it probably won't work in a SMEC at all.
If you are just asking about the socket itself, it technically doesn't matter. But, there should be a small semi-circular notch in the 1 end of the socket. This denotes the pin 1 end. It should match the chip notch, just to indicate which end of the chip should go in.
And IIRC, the notch in both the socket and the chip should be on the end closest to the center of the board, not the end closest to the edge of the board.
Barry
86 Shelby Lancer Prototype
90 Daytona Shelby VNT
91 Spirit R/T
For your questions about SDAC, please contact BadAssPerformance