So I figured I should create a project log for my 84 Dodge Omni that I bought from my brother last July. I needed a new daily driver since my 87 Horizon no longer had a floor or lower doors. My plan was to use most of the good parts from my Horizon and put them into the Omni roller that I got. I also was wanting more power than what I had in with the MPFI 2.2 in the Horizon. Since I already had a SMEC harness from the Horizon and a 2.2 T1 from my 88 New Yorker, I figured I may as well turbo it.
Here is the car shortly after I brought it home.
With a pickup load of parts.
I scrubbed clean the underhood.
And coated it with some POR15.
I soaked the knuckles and other parts in acid to remove the rust before they were coated as well.
Same with the rear drum parts.
![]()