Does anybody have a set of the (two) studs that attach the thermostat housing to the TIII cylinder head? They are M8 studs, about 3" long and have a 13mm hex near one end.
I thought about using a long bolt or some other stud, but I want the OEM ones so I can mount the stock BOV tube which piggybacks onto these studs.
Still looking. I'll buy the whole thermostat housing if it means I'll get the studs out of it..
6100 295 SCREW and WASHER, Cylinder Water Outlet Connector (this is a bolt )
6500 559 STUD and WASHER, Cylinder Water Outlet Connector (this is a stud) this was used from 1982-94 so not unique to the T3. I have these NOS or used
above from the 92 part book
Still looking....the local parts dealership says it's NS1. Unfortunately I wasn't near enough to his monitor to see what he was looking at.
These are the really long double ended studs with a 13mm wrench hex near one end.
I know I have some somewhere. I'll try and find them today. Also have the 523/ 568 cable bracket.
Sent from my XT1254 using Tapatalk
This what your looking for? Any other little brackets or little TIII stuff you may need, I'm sure I have.
Sent from my XT1254 using Tapatalk
Yes to both! I'll send a PM.
edit: Found studs, thanks Adam.
Last edited by iTurbo; 09-18-2016 at 06:21 PM.
Posting Permissions
Reply With Quote