While putting the finishing touches on the engine today I managed to break off a corner of the Shelby valve cover. Anyone have one for sale for a reasonable price?
While putting the finishing touches on the engine today I managed to break off a corner of the Shelby valve cover. Anyone have one for sale for a reasonable price?
Get it welded. Make sure you use the correct gasket for it.
I might have one. It does not use the 1 piece VC gasket. Came from and 87 S car.
Bryan
86 GLHS #161, 2016 Impala
SDAC National Member, SDAC Buckeye Chapter Member
A man has got to know his limitations.....
Not trying to be a d*ck.....why would I offer a turbo one when you asked for a Shelby VC???? Yes it is a Shelby cover.
Bryan
86 GLHS #161, 2016 Impala
SDAC National Member, SDAC Buckeye Chapter Member
A man has got to know his limitations.....
dont know your setup but i saw a chinese head that was cast wrong and caused the VC to break, make sure the head is flat in that corner
what would it cost for it to leave your hands and enter mine
what gasket was being used when it broke? The only VC I've broken was with a Fel-pro gasket and I feel with the way it fit when going on it was the cause of breaking the VC.
There seem to be a lot of broken Shelby valve covers. Not sure if there was a casting flaw or a material difference. Maybe all the broken TURBO valve covers just got thrown away.
Work your way around, gradually snugging the bolts so there isn't too much pressure in any one spot. Use a small 1/4 inch ratchet. It will help limit the amount of torque you can apply.
Last edited by ajakeski; 07-19-2016 at 08:05 AM.