My AC guy said my car doesn't have a AC low pressure cut off switch and that is should have.
SO I am asking...
Anyone have AC work done and what can you tell me about it?
Anyone discover a Consulier wire diagram they could share??
My AC guy said my car doesn't have a AC low pressure cut off switch and that is should have.
SO I am asking...
Anyone have AC work done and what can you tell me about it?
Anyone discover a Consulier wire diagram they could share??
Great stuff for great cars! Poly engine mounts and bushings at: http://www.polybushings.com
George Lawson did all the wiring on the cars. I can send him a message. He does not have a diagram. I have asked.
This just in from george-
"Yes it does, it's on the receiver dryer mounted on fire wall."
I didn't see it, but will look again....thanks.
Great stuff for great cars! Poly engine mounts and bushings at: http://www.polybushings.com
Benji might be the best person to ask since his car is apart.
Wiring is stock except it has an extension in the harness and aftermarket gauges. Some wires run in the center console, most along the drivers rocker.
From what I've seen of the wiring, you've got the stock stuff at the engine, but with a bulkhead jumper in the dash.
Meaning, imagine the stock wiring in a stock k-car, but instead of the bulkhead connector coming through the firewall and leading straight to the dash it goes to the back seat where all of the gauges are. ok maybe that's a bad analogy but the car has 2 bulkhead connectors.
There is a bulkhead extension of about 3.5 feet ( maybe less )
ENGINE--BLKHD--gauges
ENGINE--BLKHD---------BLKHD--gauges
The bulkhead jumper is custom ( wires are wrong color, but go back to stock on the far end ) and the gauges are custom, but it's no different than installing aftermarket stuff in a stock fwd mopar.
As for the A/C. The parts list shows 00405 as the evap unit ( danhard inc ). I called them and they're sending me the install instructions. I'll forward it over to you when I get it.
This whole wiring talk makes me wonder if we could add a traveler computer...hmmm ( just thinking out loud )
Last edited by player1up; 04-06-2016 at 11:06 AM.
I have the low pressure switch wiring in the engine bay but the car doesn't have any AC components installed.
Johnny/Benji, you have email
Do our older AC systems have more than 1 switch? (High and low) I know my newer ones did but I didn't think the older ones did?
I don't think so, in the traditional sense. no "Max A/C" just on with fan low, med, high
I looked and found the switch! 😀
I was hidden under the water fill tank.
Great stuff for great cars! Poly engine mounts and bushings at: http://www.polybushings.com