Hello,
I'm willing to buy an Oil Cap. The parts store/aftermarket ones are crap and leak a bit. Something oem or real close to it. I've looked on ebay and such but they seem overpriced. Lmk what you have.
It'll be going on a late 80's Turbo Valve Cover. So anything from that timeframe. Thanks! I'm paypal ready.
You can buy an inexpensive Stant oil cap and remove the rubber washer out of it and replace your petrified one and your original oil cap will probably be good as new. Stant #11066 or 10066 should work. It will look a bit different (metal two eared) but the internals are the same as OEM. I've done this to probably a couple dozen caps over the years. Depending on with cap you had as original, Stant was one of the OEM suppliers for Chrysler.
Todd
1989-90:
Mopar #4483110 /RAISED WHITE LETTERS 3 INCH DIAMETER used/TURBO
have 12 NOS 25.00 each
and 16 used 8.50 each
1984-88:
Mopar # 4105484 used/TURBO W/O LETTERING
have 7 NOS 35.50 each
have 31 used at 20.00 each
1987-88
Mopar # 4343715 W/O TURBO /4 CYL /STENCILED LETTERS
have 4 used at 12.00 each
1990-91
Mopar # 4483642 w/o turbo
have 5 NOS 28.50 each
1991-92
Mopar # 4621012 "ENGINE OIL FILL" IN WHITE PAINTED LETTERS used /EFI
have 6 NOS 25.00 each
have 6 used 12.00 each
1991-93
Mopar #4484490 /T3 16 valve
have 17 NOS 40.50 each
www.arizonaparts.com
Last edited by martin kolner; 03-31-2016 at 07:16 PM.
pm sent. I make repo CS oil caps, but if you're looking for a cheap solution this is probably not on your radar.
Problem is that I don't have the original oil capOriginally Posted by 4 l-bodies
I'll take a used one of these! I checked out the site but not sure on how to order?
e-mail or call me that info is at the site
Posting Permissions
Reply With Quote