Results 1 to 12 of 12

Thread: MiniVan Parts Wanted

  1. #1
    Supporting Member II Turbo Mopar Contributor ajakeski's Avatar
    Join Date
    Sep 2007
    Location
    SE Wisconsin
    Posts
    2,624

    MiniVan Parts Wanted

    I need the following interior parts for my 1989 Voyager:

    Dashboard center stack door. I need the a wood grained one with a good latch so it stays closed

    Driver's door inside handle trim bezel without broken tabs.

    Four seat hook covers for the floor so I can keep things out of the seat hook holes. Gray preferred, but I do have paint.
    Attached Thumbnails Attached Thumbnails Click image for larger version. 

Name:	IMG_3725.jpg 
Views:	86 
Size:	1.68 MB 
ID:	57594   Click image for larger version. 

Name:	IMG_3724.jpg 
Views:	119 
Size:	1.74 MB 
ID:	57593   Click image for larger version. 

Name:	IMG_3726.jpg 
Views:	115 
Size:	1.70 MB 
ID:	57595  

  2. #2

    Re: MiniVan Parts Wanted

    the seat covers or escutcheons are here

    which ones do you need?

    4314 742 AR STRIKER and BOLT, Seat Retension Front (Use 6500927 Nut)
    2 AR SCREW, (8-15x1) (Not Serv.)
    3 ESCUTCHEON, Seat Hold Down (Short)
    S657 FC5 AR Blue
    S657 GR8 AR Red
    S657 EK3 AR Almond
    S657 CS8 AR Charcoal
    4 FLOOR PAN, (Reference)
    5 4337 594 AR STRIKER and BOLT, Seat Retension Rear
    6 FILLER, Rear Floor Striker, 5 Passenger (Not Serv.)
    7 COVER, Seat Escutcheon 7 Passenger
    S655 FC5 AR Blue
    S655 GR8 AR Red
    S655 EK3 AR Almond
    S655 CS8 AR Charcoal
    8 ESCUTCHEON, Hold Down (7 Passenger) (Long)
    w/112" Wheelbase
    S656 FC5 1 Blue
    S656 GR8 1 Red
    S656 EK3 1 Almond
    S656 CS8 1 Charcoal
    w/119" Wheelbase
    S688 FC5 1 Blue
    S688 GR8 1 Red
    S688 FK3 1 Almond
    S688 FS8 1 Charcoal
    9 6501 269 AR NUT and WASHER (Use 6500927 For # 1 Bolt) ***

    I have a good assortment of these covers NOS or used in lots of colors

    4460655 is the upper console door

    4184790 is R/L door handle bezel I have these NOS or used

    www.arizonaparts.com

  3. #3
    Supporting Member II Turbo Mopar Contributor ajakeski's Avatar
    Join Date
    Sep 2007
    Location
    SE Wisconsin
    Posts
    2,624

    Re: MiniVan Parts Wanted

    I popped one out to measure it and saw that Chrysler knew I would need these 25 years after the van was built. The back of the cover is embossed with" Order additional parts form dealer 4248520"

    I need four. It's a short wheelbase van.
    Attached Thumbnails Attached Thumbnails Click image for larger version. 

Name:	IMG_3734.jpg 
Views:	80 
Size:	2.23 MB 
ID:	57599   Click image for larger version. 

Name:	IMG_3735.jpg 
Views:	77 
Size:	2.37 MB 
ID:	57600  
    Last edited by ajakeski; 03-17-2016 at 04:40 PM.

  4. #4

    Re: MiniVan Parts Wanted

    4248520 is the casting # for S655XXX XXX=color code

    I have these

    S655CB5 blue (11)
    S655CM6 red (3)
    S655CT8 brown (30)
    S655DT5 tan (12)

    the above fit 1984-85 minivan....part is the same but the colors are different

    ( )= QTY all are NOS 4.00 each plus shipping

    www.arizonaparts.com

  5. #5
    boostaholic
    Join Date
    Jan 2008
    Location
    Penn Hills PA
    Posts
    1,331

    Re: MiniVan Parts Wanted

    Quote Originally Posted by ajakeski View Post
    I need the following interior parts for my 1989 Voyager:

    Dashboard center stack door. I need the a wood grained one with a good latch so it stays closed

    Driver's door inside handle trim bezel without broken tabs.

    Four seat hook covers for the floor so I can keep things out of the seat hook holes. Gray preferred, but I do have paint.
    Ill check the van I purchased this weekend

  6. #6
    boostaholic
    Join Date
    Dec 2012
    Location
    Houston
    Posts
    1,265

    Re: MiniVan Parts Wanted

    Do you know Doc Brown or Marty? haha

    Quote Originally Posted by ajakeski View Post
    I popped one out to measure it and saw that Chrysler knew I would need these 25 years after the van was built. The back of the cover is embossed with" Order additional parts form dealer 4248520"

    I need four. It's a short wheelbase van.

  7. #7
    Supporting Member II Turbo Mopar Contributor ajakeski's Avatar
    Join Date
    Sep 2007
    Location
    SE Wisconsin
    Posts
    2,624

    Re: MiniVan Parts Wanted

    Covers and door handle bezel have been found. I'm still looking for a good console door.

  8. #8
    Supporting Member II Turbo Mopar Contributor ajakeski's Avatar
    Join Date
    Sep 2007
    Location
    SE Wisconsin
    Posts
    2,624

    Re: MiniVan Parts Wanted

    I haven't had any luck finding a good console door, so I took mine apart to see if it's repairable.

    Quite the Rube-Goldberg design inside there. There's a few plastic pieces that work in concert to release the latch. One piece has (had) a pivot rod cast onto each end and both rods were long gone, broken.

    3D printing to the rescue again.

    The new part looks like a match and seems stronger than the original. I'll try it tomorrow to see if it works.
    Attached Thumbnails Attached Thumbnails Click image for larger version. 

Name:	IMG_4045.jpg 
Views:	101 
Size:	2.17 MB 
ID:	57832  

  9. #9
    Buy my stuff!!!!!!!!!!! :O) Turbo Mopar Vendor turbovanmanČ's Avatar
    Join Date
    Dec 2005
    Location
    Abbotsford, BC
    Posts
    44,167

    Re: MiniVan Parts Wanted

    Nice. Those 3D printers are going to be life savers.
    1989 FWD Turbo Caravan-2.5 TIII, GT35R, auto, a/c, cruise, pwr windows/locks, fully loaded with interior and ran with full exhaust. RETIRED FOR A FEW YEARS! 12.57@104 :O)
    1984 Chev Getaway van, 6.2 Diesel with a remote mounted turbo setup burning WMO-For sale.
    2003 GSW 2.0L TDI, auto, fully loaded, modified, 360K-wife's.
    2004 GSW TDI, 5 speed, fully loaded, modified.

    Aurora ignition wires for sale. Link to info

    Super60 roller cams or custom/billet cams. Link to info

  10. #10
    Hybrid booster
    Join Date
    Mar 2006
    Location
    Central VA
    Posts
    687

    Re: MiniVan Parts Wanted

    I took two of the doors to make one working one.

  11. #11
    Supporting Member II Turbo Mopar Contributor ajakeski's Avatar
    Join Date
    Sep 2007
    Location
    SE Wisconsin
    Posts
    2,624

    Re: MiniVan Parts Wanted

    Quote Originally Posted by rare_ram View Post
    I took two of the doors to make one working one.

    It seems like it wasn't Chrysler's best design. Probably was designed by a new guy or someone counting his days.

  12. #12
    Garrett booster
    Join Date
    Aug 2006
    Location
    Orange Park, Florida
    Posts
    203

    Re: MiniVan Parts Wanted

    Quote Originally Posted by ajakeski View Post
    It seems like it wasn't Chrysler's best design. Probably was designed by a new guy or someone counting his days.
    The one in my van is hard to open.

Similar Threads

  1. Wanted Turbo Minivan Wanted
    By ajakeski in forum Cars
    Replies: 129
    Last Post: 01-30-2017, 10:10 AM
  2. Interior Wanted 5speed minivan pedal box
    By shelbyconcepts in forum Parts Wanted
    Replies: 2
    Last Post: 05-06-2016, 06:42 AM
  3. General Wanted : any and all parts for 1989/90 Turbo minivan
    By gubbylee in forum Parts Wanted
    Replies: 3
    Last Post: 01-04-2014, 08:23 PM
  4. Wanted Wanted:1989/90 Turbo Minivan
    By gubbylee in forum Cars
    Replies: 1
    Last Post: 12-30-2013, 09:59 PM
  5. Wanted Rust Free Minivan Body Parts
    By Turbodave in forum Parts Wanted
    Replies: 6
    Last Post: 09-22-2007, 11:42 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •