Code 36 is not shut off, even when it is suppose to in T-LMv13

[tryingbe]

I'm using T-LMv13.

I physically deleted the wastegate solenoid since I'm using an aftermarket boost controller. Disabled the code 36 in T-LMv13.

Check Engine is ON.
Key on and off DOES NOT flash code 36.
Scanner shows code 36 on


As a test, I disabled code 12 in T-LMv13.

Key on and off DOES NOT flash code 12.
Scanner shows code 12.


Help!

[cordes]

I'm in on this one too. I've got a CEL which will come on and stay on whenever I go into boost with my NYer and it always goes off on a restart. No code stored. Overboost works fine so I don't think it's the map.

[tryingbe]

Code 36 also triggered Code 45 and then engine will completely cut-out anything higher than 0 vacuum.

I wired the boost solenoid back in for now.