Having some trouble with MPScan.
I was having connection issues last Nov or so before dropping MeanMini off at Brian's shop.
Now that she is back, I am trying to get some logs so i can make some tuning adjustments.
I am getting errors that say failed to connect and to cycle the key off-on. But, it does not work, and then when I click record again it closes MPScan abruptly.

Here is the port log:
mpscan ver - 2.0.3.3 (3/4/2016 1:15:21 PM)
Microsoft Windows XP Professional - Win32NT
trying to open port COM17 - ctlrecord_click
got a good port back - ctlrecord_click
try to open port COM17 -initport
COM17 is a legit port -initport
usb is available on COM17 -initport
usb ftdi serial number BBS3XE4O2J is available - initport
[usbportinit] setting port baud rate to 7812
ftdi open successful on COM17 -usbportinit
using protocol SMEC T1:1
attempt to change ecu baud rate to 62500
Sending byte 18
Received 0 byte(s): 0
Read confirm byte failed (status:0 - count:0)
Sending byte 18
Received 0 byte(s): 0
Read confirm byte failed (status:0 - count:0)
Sending byte 18
Received 0 byte(s): 0
Read confirm byte failed (status:0 - count:0)
Sending byte 18
Received 0 byte(s): 0
Read confirm byte failed (status:0 - count:0)
usbsethibaud failed - usbportinit
ftdi open unsuccessful - usbportinit
Sending byte 254
Received 0 byte(s): 0
Read confirm byte failed (status:0 - count:0)
Sending byte 254
Received 0 byte(s): 0
Read confirm byte failed (status:0 - count:0)
can't open ftdi port - usbportinit
Unable to open/setup port. - ctlrecord_click


Here is the Coms:
-Comport analysis for mpscan version 2.0.3.3 (3/4/2016 1:12:23 PM)
-Locating ports on computer-
name:USB Serial Port (COM17) deviceid:FTDIBUS\VID_0403+PID_6001+BBS3XE4O2JA\000 0
name:Communications Port (COM1) deviceid:ACPI\PNP0501\4&61F3B4B&0
number of ftdi devices found - 1
ftdi port num:COM17 serial num:BBS3XE4O2J
Inverted tx:True Inverted rx:True
Vcp driver loaded:True
Latency is set to:16
checking to see if usb port number COM17 is a moates device
Moates device not located on this port
default com port set to:COM17

I'm wondering if it is a bad cable?
Is that baud rate change correct?

I did try MPScan on Slugmobile and it made a log, but don't know if it was some sampling issue as it looked like several duplicated readings.

Any help from the smart folks is appreciated. Was hoping to possibly race this Sunday, if I can get some logs and make some adjustments tomorrow.