Then, I thought why not see if I can narrow the K frame mounts and actually fit a full width K based K frame in the car! Next came the cutting wheel, sawzall and welder! Within a few hours, I had a full width Daytona K frame in an L body! What I did was section out and narrow the rear ears on the K frame to fit the L body studs. For the front mounts, I cut the pedestals off the Daytona frame and the original Rampage frame. Once cleaned up, I was able to weld the L body pedestals to the Daytona frame in the correct locations to make the k frame a complete bolt on that fits just fine between the L body frame rails.