2004 SRT4 head to 96 2.0L DOHC intake manifold-will it work?

[turbovanman²]

Sorry guys, don't have time to read, too busy working and moving house. I am putting an SRT4 motor where the 2.0L DOHC used to be. The stock intake fits 3 bolts at the thermostat housing and the bottom right, looking at it. If I drill the manifold in the center, one more fits. Is that enough or do I need to drill more holes as it looks like a few more might fit If I drill the manifold. TIA

[BadAssPerformance]

I thought the ports were different shapes on the SRT-4 heads?

[TurboGLH]

Port shape should be the same, but you should drill out all the bolt holes to ensure a good seal.

[turbovanman²]

I thought the ports were different shapes on the SRT-4 heads?

Intake no, exhaust yes.

[BadAssPerformance]

Intake no, exhaust yes.

Gotcha.

[David Bohrer]

It will seal up just fine. Measure twice and drill once. I didn't and ended up with a oblong hole which pisses me off every time I look at it.