Found an ultimate 3 inch bend for my ATP downpipe.
As tight as it'll go!
http://www.ebay.com/itm/350977132953
Just need to get it welded.
Found an ultimate 3 inch bend for my ATP downpipe.
As tight as it'll go!
http://www.ebay.com/itm/350977132953
Just need to get it welded.
Last edited by tryingbe; 10-19-2015 at 12:26 PM.
I've used those before, they work great but they're not technically a bend, it's two stampings seam welded together
AJ (no More Alan) 84 Rampage RT TIII/568 Quaife 87 GLHS dealer optioned Red 16V Masi/568/Quaife
90 Masi 16V White/Ginger/Black
89 TC Masi 16V Red/Ginger/Black
86 GLHS #110 RoadRace Built 89 CSX-VNT Recaro Car
89 Turbo Mini 'Woody' 85 GLHT 'RedBox'
2014 Explorer DD'r 3.5Twin Turbo Ecoboost AWD and 500HP
My profile page has over 20,000 views, I'm somebody LOL
Mmmmmmm, metal donuts!!!
I do not wanna try the coffie that would make that go down easier ...
but nice , any final radius you need just cut it out
why do you need such a tight radius when Todd Nelson has shown us a nice 4.5" radius works just fine with the ATP and ZF pump????????
Also if you just wanted a 90 out of it you could of just gotten a "short radius" 90 which has the same 3" radius as that donut. Would of been a lot easier.
I'll just leave this here
Diameter = Radius x 2
Last edited by tryingbe; 10-19-2015 at 08:33 PM.
That's not how pipe radius is measured though. It's measured along the centerline of the pipe, which is 6" across 9-1.5*2=6" diameter /2 =radius aka 3" aka "Short" turn radius.
What's done is done. I'll give up a few hp to know there is more clearance for the plastic reservoir.
All done.
HELLO,,
Newbie here,,
Does any one have a 3" exhaust that they wish to sell?
For Spirit R/T?
THANKS
I tried to POST,,but cann't see how to do this,,,,,,,?
Any help would be a help.
I even sent out to contact us with no reply back!!!
New year day?
Call next week and see what happens.