Pictures available upon request!
A568 transmission!!, small spline. Works great. $500 + ACTUAL shipping costs!! See pics below! See special deal note!!
***SPECIAL DEAL*** Anyone who buys the A568 tranny at the above price gets 1 free item below with a price up to $50!
forged rods, set of 4, (2.5 T1) p/n 4323958 $85
Stock 2.5 T1 roller cam $40
new HEP, borg warner p/n ME55 (works on 2.5 T1). AFAIK this is the same one Chrysler sells. New in Box. $20
ZF pump w/ bracket. Have not tested it but have no reason to believe it has problems. $60
G-head: Cleaned and surfaced but not pressure tested. Comes with valves, springs and retainers. $75 + ACTUAL shipping cost
Massive G-Body Intercooler setup w/piping! Equivalent to 4 stock cores, bar and plate, fins inside and out, no epoxy. Same side in/out. 2.5" piping through front bulkhead. Requires use of lawnmower battery to fit pipes, I will include a custom lawnmower battery bracket, but you will probably need to modify stock wiring setup so things fit nicely. I'll include all couplers as well. Piping is custom cut bends TIG welded together with beads formed into ends for couplers. Detailed pics available of course. This is a great intercooler setup for the G-body and could save you alot of time and money. $200 + actual shipping.
Stock 2.5/T2 injectors p/n 5277865, set of 4, work great, passed California SMOG only a few thousand miles ago $45
1 piece fuel rail, no dampener, great condition. Includes little bracket that pinches lines together and bolts to head. Includes regulator line as well. *note* you will need a new crush oring for the regulator. $30
4 injector clips, mount injectors to rail $10 shipped
Stock rod bushing for T2/2.5L rods stock wrist pin size *must be honed* *Chrysler brand* $10 shipped
O2 sensor, 4 wire, BOSCH, replaced only a few thousand miles ago, passed smog. $20 shipped
G-body ball joints NIB! Set of 2, Gp Sorenson brand $25
Tachometer Remote mount w/pickup, like new condition, equus brand, 8krpm, $25, perfect for modified vehicles with no tach!
2.5" swingvalve. I believe this is the biggest you can get before going 3". Has a bit of grinding done to the outer surface to fit a header. Pics avail. $70
Intermediate shaft (axle) w/bracket Seemed to be working smoothly! $40
Intermediate shaft (engine) From a 2.5 T1 common block. About 35k on since it was re-ground. $40
Distributor From a 2.5 T1 common block. I believe its original chrysler. Includes cheap wires,cap, and rotor, which are all usable still. No hep. (sold separately above) $30
Factory service manual! 1990! Includes 4 books: "Wiring Diagrams", "Electrical, Fuel & Emissions", "Engine, Chassis, and Body", and "Service manual supplement Wiring Diagrams for G/J body". The engine book is heavily worn and greasy because of all the usage, but its still perfectly functional with no missing pages. The other books are somewhat greasy and worn. $40
Powertrain diagnostic procedures 1990. Meant to be used with a DRB2. $15
Haynes Chrysler 82 to 95 FWD service manual Filthy, water stained, but not falling apart and totally readable. Good backup manual to have in the car at all times or what not. Plus if you are learning, its a good 2nd opinion on how to do things. $10
Chilton 81 to 95 4wd 4cyl Chrysler repair manual Much better condition than the haynes. $10
I am also parting out a 1990 Daytona 2.5 ES turbo. So if you have specific parts request just ask!
Shipping to Canada is available, just ask!
SOLD ITEMS:
$SOLD!!+2mm exhaust valves for G head. New, still in box. P/N 4876670 $SOLD!!
$SOLD!!+2mm exhaust valve seats, New, still in bags. P/N 4349126 $SOLD!!
$SOLD!! 3 bar map sensor, works great! $SOLD!!
$SOLD!! +40 injectors, set of 4, tested good at witch-hunter a few thousand miles ago.$SOLD!!
$SOLD!! 1990 Daytona ES 2.5 T1 airbox (yes the weird rectangular one) includes accordion tube and great condition oval to turbo rubber tube $SOLD!!
$SOLD!! Wideband,Innovate LC1. Includes sensor, module, and gauge.$SOLD!!
$SOLD!! Greddy Type RS BOV with adapter to 2.5" piping/couplers $SOLD!!
$SOLD!! 3" downpipe, same one you get from FWDP/TU $SOLD!!
$SOLD!! w/ chrysler cable and cartridge for TD's $75 If interested PM and I will find out exact cartridge it has.$SOLD!!
$SOLD!! Set of THREE Stock Cast Mahle 0.030 over 2.5 T1 pistons $SOLD!!
$SOLD!! Copper head gasket shim, definitely used, but still good
$SOLD!!G-body Turbo air scoop[/B], this is the metal + rubber scoop that mounts to the K-frame and directs air up to the turbo, includes bolts $SOLD!!
$SOLD!!4 puck clutch w/ yellow PP + stock TO bearing! $SOLD!!
$SOLD!!AFPR. The black one by Accufab. Used but works great. $SOLD!!
$SOLD!!POLY MOUNTS Set of all 4 for 90 daytona. $SOLD!!
$SOLD!!3" exhaust system w/muffler. $SOLD!!
$SOLD!!Walbro 255 in-tank pump 35k miles on it, works great! $SOLD!!
$SOLD!!Mopar performance book for 2.2/2.5![/B] 4th edition. P/N P5007162 $SOLD!!