What would you want for the driver side quarter and rear bumper cover?
What would you want for the driver side quarter and rear bumper cover?
I have a few pending PM's I'll try to address in the next few days folks, been a tough week between work and trying to clear the GLHS out of my garage. I'll try to find homes for the parts tonight and work on some shipping inquires.
Working on clearing the decks.
Under dash harness is sold, shipping out this weekend.
Working on clearing the decks.
Saturday, September 26 MOPARS @ The Valley plus NETO and Open Test & Tune
If you are planning on going to Lebanon Valley next weeked I'll be there with the CSX, great chance for free shipping on anything large or small! I'll just toss it in the back of the truck. Make an offer, I'll even knock a few bucks off for not having to pack anything.
Gary
Working on clearing the decks.
Don't take the Daytona rad+intercooler!
do you happen to have any mahle 2.5 std bore pistons? I need a set and I'm only an hour from the valley!!
Another PM sent.
PM'd you.
Thanks,
Guy
Hope you feel better, contact me when you can.
Guy
Sorry to hear you're not feeling well. I'll be patient.
Feeling 85% better today, congestion almost gone. Making a run to the post office this morning on a few packages.
Working on clearing the decks.
Sweet thanks Gary!
Any luck locating the 2-piece rail?
Do you have an known good t2 turbos?
No just smokers at the moment.
FYI- Now that the furnace and hot water heater installs are done I need to try and make Cecil County next month. I have a few packages I have to get out the door for folks with great patience and then I'll not be able to do much in regards to parts sales till after.
The exception being if you are going to be at Cecil County and then I can toss stuff in the truck for a free ride down. If you expect 50 pictures of an item in question with arrows and diagrams I'll have to decline due to time constraints. I have not only the CSX to get ready (along with some needed service to truck and trailer) but a special after hours project for my boss too.
Gary
Working on clearing the decks.