P body door rod holders

[cordes]

The plastic clasp that holds the rod that comes from the interior handle is broken on the CSX. As a result I have to use the outside door handle to get out of the car. Is there a replacement available for these or do I need to hit up the JY and pray to find a good one?

[135sohc]

http://www.clipsandfasteners.com/sea...earch=rod+clip

Make sure you take notice of left handed vs right handed in the installed orientation.

[cordes]

Thanks a ton for the link. They must have used them on everything for them to still be making these.

I guess these would work for now and in the future when the other ones break?

http://www.clipsandfasteners.com/Doo...r_p/a10262.htm

[83scamp]

Thanks a ton for the link. They must have used them on everything for them to still be making these.

I guess these would work for now and in the future when the other ones break?

http://www.clipsandfasteners.com/Doo...r_p/a10262.htm

Yep, remember, when these cars were new, Chrysler was run by a bunch of cheap-@sses. Anything they could use on multiple bodies without re-engineering, they did. Which is good for us, because that means parts transfer easily between body styles...

Shoot, I found out while restoring my Scamp, that the clips used to hold the rear window trim on are actually GM clips!

[cordes]

Ordered up the clips. Hope to have them here soon so my driver's side door will be fully functional again.

[cordes]

To update this thread, I got the pack of left and right pieces. They worked perfectly and the door is working flawlessly.