So one of my goals with using Asa's dual thermocouple gauge kit was to send the intake charge temp to the computer. There is the input available already, and just needs a wire on that pin?
Some follow up questions:
Will MPScan be able to read/log the charge temp without there being a check in the configuration box? Is that box just to enable the additional modifiers for charge temp?
If you can have a temperature input, without allowing any control, and are able to monitor the reading for operator information only, could you then use any temperature input you'd like? Specifically, could i configure that temerature input for a EGT reading?
I'm interested in being able to switch the input between the two outputs on my gauge. This way i could get logs with my charge temp, and my EGT on different runs.