Can you get the clips that go into the channel of the black trim that goes above the window? My trim piece looks good, but the clips are broken and I those to reinstall it obviously.
Can you get the clips that go into the channel of the black trim that goes above the window? My trim piece looks good, but the clips are broken and I those to reinstall it obviously.
I found clips that worked at the local Bumper To Bumper auto parts store.
I found clips that worked at the local Bumper To Bumper auto parts store. I'll look and see if I have the part number.
Not yet, Lots of boxes to go through.
Autoboy master by Auveco Part number PM41092
They list the clips as being for GM, but they worked on our CSX-T
I'm pretty sure these are the same. I ordered a package. If anyone needs some (Gary) just let me know. I know that I don't need 50 of them.
http://www.amazon.com/Quarter-Belt-R...+Moulding+Clip
What are people doing for the adhesive on the trim?
Those look the same as the ones I used.
For trim adhesive 3M is the way to go.
http://www.autopia-carcare.com/3m-su...Q#.VWpymHA8KrU
if anyone knows where to get replacements for the lower rear quarter window round push button type clips i need those
Thanks a ton for the link. I found it on Amazon with a 15' length for less than $10 shipped.
http://smile.amazon.com/3M-03614-Sco...t+Tape+-+03609
The trim clips came in the mail today. While not 100% exactly the same I think they should do the job with no issues at all. Gary, I'll try to get yours out to you when my wife goes to the PO next.
The tape in the link is what I use. If it's too thin, ues two layers.
Just finished reinstalling the trim. It looks way better than it did before removal, although it still leaves a little to be desired where it meets the bottom piece near the mirror. That's due to some careless removal in the past if I had to guess though. The clips and tape worked well. I ended up using three layers of the tape which I'm pretty sure was unnecessary.
I hope to have your clips out tomorrow or Saturday Gary.