What does the SBEC use these wires for?

[fastasleep]

I want to eliminate a bunch of these conductors that tether the SBEC main connector to the Bulkhead connector. What do these do, and can I eliminate them?

SBEC pin #:

29- Brake sensor signal. I eliminated the cruise control completely, so it seems this is not needed.
43- tachometer signal. I do not have a tachometer in my cluster, and I am planning to install an aftermarket AutoMeter tachometer. I will use the coil to derive a signal.
48- Speed control switch. I removed the cruise control.
49- Speed control feed. I removed the cruise control.
50- Speed control resume. I removed the cruise control.
54- Turbo solenoid #1. I have no factory boost control. I am using an MBC.
56-Turbo solenoid. I have no factory boost control. I am using an MBC.

I am attempting to totally divorce the SBEC harness from the bodyharness, while stripping both harnesses of anything that is not necessary. I will control the fuel pump relay and fanrelay from toggle switches. The starter relay will still be triggered from the ignition switch.

[Reaper1]

I could be wrong, but I think that at least the boost control solenoid terminals need some sort of resistance to prevent the CEL or a code. The speed control stuff...yeah, I'm 99.99% sure you can yank that. Tach...hmmm...if you aren't going to run a navigator then I think you can yank that one, too. The brake sensor signal, I think you need that. I could be wrong, but I think there are certain operations that get activated whent he brake signal is turned on or off (5Digits or ShelGame could probably tell you for sure).

[ShelGame]

You can mask out the code for the solenoids so they don't set the CEL...

[fastasleep]

Reaper, what is Navigator? I'll search for it. Thanks, man!!!!

Rob, I just remembered that my 2-step is activated by the brake switch....do I need that for any other function? I could just ground that wire from the SBEC to trigger the 2-step with a momentary? Can you change my cal to mask the CEL's?

Any other reasons to put this stuff back?