Trying to utilize the Innovate MTX-L wideband as the sole O2 sensor on MeanMini. On the recent rebuild the 0-1V output was used to give the O2 signal to the smec. I was trying out the 0-5V output and trying to configure the WB2NB feature in the turbonator cal.
The issue I've found is during a warm restart of the car. The wideband output is basically nil when the car first starts due to the sensor heat-up cycle. It signals the smec with basically a lean condition which appears to make the car try to correct.
Is there something else that needs to be adjusted when using this feature? I think the work around might be to alter the open loop mode to be activated even on a warm restart.
Any thoughts?
Is anyone else using just their wideband to read to a turbonator smec? The other thread was discussing using the 0-1V output.