2.2 T1 throttle body/cruise control linkage question, pictures needed

[glhturbo1985]

Can someone snap a picture of what the E-clip or retaining ring look like that hold the cruise control linkage to the shaft attached to the throttle body of a log intake manifold Turbo 1?

On my 84 Turbo Z, whatever was keeping the cable in place (likely a pin or E-clip), has come off and occasionally 'when the stars align' the cable will slip off the linkage. The cruise works fine well when the linkage is attached and I’d like to keep the TZ as reliable as it can be.

Many thanks.
I've attached 2 photos to show my problem

[ShadowFromHell]

I think they used a e clip. But you could probably just put a zip tie on the shaft. I did that on on one of my neons.

[Ramp]

In the past i've used a small washer and a small hairpin clip (can get an assorted package at advance auto). It works very well. Never had one come off.