Results 1 to 3 of 3

Thread: Custom intake plenum help

  1. #1
    Mitsu booster
    Join Date
    May 2012
    Location
    Saskatoon
    Posts
    2

    Custom intake plenum help

    I'm looking to install parts collecting dust. I have a complete top end I'm looking to install. One of which is a Lengel upper intake plenum that rests on a two piece intake lower. I'm a novice mechanic at best and have help at times. My question is where have others tapped into the plenum and how should the vac lines be arranged. Did others tap the brake boost hole closer to the throttle body still or ran a line to the end cap and tapped two holes for vacuum. One for a vac block , other for brakes. 2.5 common block in a 90 Daytona.

  2. #2
    Garrett booster
    Join Date
    Aug 2007
    Location
    va
    Posts
    93

    Re: Custom intake plenum help

    It shouldn't matter where you tap into the plenum for vacuum ports.

  3. #3
    Buy my stuff!!!!!!!!!!! :O) Turbo Mopar Vendor turbovanmanČ's Avatar
    Join Date
    Dec 2005
    Location
    Abbotsford, BC
    Posts
    44,167

    Re: Custom intake plenum help

    It doesn't, but keep the MAP on its own.
    1989 FWD Turbo Caravan-2.5 TIII, GT35R, auto, a/c, cruise, pwr windows/locks, fully loaded with interior and ran with full exhaust. RETIRED FOR A FEW YEARS! 12.57@104 :O)
    1984 Chev Getaway van, 6.2 Diesel with a remote mounted turbo setup burning WMO-For sale.
    2003 GSW 2.0L TDI, auto, fully loaded, modified, 360K-wife's.
    2004 GSW TDI, 5 speed, fully loaded, modified.

    Aurora ignition wires for sale. Link to info

    Super60 roller cams or custom/billet cams. Link to info

Similar Threads

  1. 2.2/2.5 big plenum custom intake GROUP BUY
    By acannell in forum Exotic Electron
    Replies: 299
    Last Post: 03-12-2015, 09:11 PM
  2. Engine TIII Custom large plenum intake manifold
    By yogurt_slinger in forum Parts For Sale
    Replies: 5
    Last Post: 01-29-2013, 05:04 PM
  3. General Half round alum plenum stock for custom intake.
    By rx2mazda in forum Parts For Sale
    Replies: 11
    Last Post: 05-07-2010, 09:59 PM
  4. Custom Large Plenum 8V Intake Manifold FS
    By Dave in forum Parts For Sale
    Replies: 24
    Last Post: 11-20-2007, 10:20 AM
  5. Nitrous bottle for a custom intake upper plenum?
    By turbovanmanČ in forum Engine - Block, Piston, Heads, Intakes
    Replies: 15
    Last Post: 11-23-2006, 04:47 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •